Onkyo TX-NR905 Protection Circuit Activated After hooking up all the components the reciever run but inmediatly turns off and the standby button blinks. I have disconnected all the inputs and wait for
...Onkyo TX -DR555 receiver's master volume cuts out at a certain volume level whereas it did not before . All the connections and speaker specs are correct. Please advise many thanks Hold the VCR/DVR ...
Onkyo TX SV7M Knocked out by Power Surge We had a desert snow storm and the power went out while the receiver was operating, now the receiver only turns on, no sound at all. Any help would be ...
protection kicked in, now it only comes on for a second and then goes into standby mode. It says to call Onkyo repair for this problem but closest to me is almost 500 miles away. Isn't there some kind
Onkyo TX-SV414Pro. No audio. Displays "Protect" something is wrong either in one of your speaker connections or in the unit itself unplug for awhile to reset.try it again.make sure all connections are
...Onkyo website - usually a malfunction in the unit requiring service, and you cannot reset it. HOWEVER, try the usual unplug, wait and plug-in again. Make sure that there's not a shorted speaker - so ...
...Onkyo Tsxr 577 amp. The wires on the speakers crossed and the amp stopped working. It might be in autoprotect mode and I don't know how to reset it. The amp protection circuit has been activated. ...
...unit with out any speaker connected if it still goes to PROTECT try factory reset if possible. To reset the AV receiver to its factory defaults, turn it on and, while holding down VCR/DVR, press ...
Question about Ht-Rc180 7.2-Channel A/V Surround Home Network Receive
onkyo ht-rc180 standby light blinks will not start.i tryed factory reset, still blinks The amp protection circuit has been activated. Remove the power cord from the wall outlet immediately. Disconnect
Question about Ht-Rc180 7.2-Channel A/V Surround Home Network Receive
...ONKYO tx 8511 is protect mode How to reset Hi Vinoth, if this has not been resolved I would advise you to disconnect the unit from the AC Outlet for at least an hour and then see if it is out of ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions