Questions & Answers for: Brother DCP loose spring

...up with an error message saying printer fault usb005. Remote downlevel document. I can't find any loose connections. Any ideas? USB port is set wrong on driver... Unplug usb, delete driver, ...

Laser printer does not print Hi, I have a Brother HL-1440 laser printer at home. It prints out files fine, then stops to print now. When I check the status of the printer, it says "Out of Paper" when ...

...spring, if its loose should be hanging by one of it ends using very small tweezers or needle nose pliers, you should be able to hook it back to the lever/sensor, it has a hooked end where the spring ...

Back Door is open. Printer will not work. Keep Back Door is open. Printer will not work. Keep getting same message. The black flap inside the rear door has a sensor flag mounted on it. The flag goes ...

Says the back door is open but it is not will not work When you open the back door there is a black guide that snaps in place covering the fuser. There is a black rod near the center that has a sensor

...spring, if its loose should be hanging by one of it ends using very small tweezers or needle nose pliers, you should be able to hook it back to the lever/sensor, it has a hooked end where the spring ...

...to the mainboard by simply sticking it into position. May or may not work, it may have wiggled loose. machine error af "brother

paper jams in first rollers out of paper tray one sheet will feed but several will jam Check for wear on the first set of rollers. If they seem fine and your print settings are correct (media type and

dcp 7020 paper jams The printer jams, usually on the second and later pages. There is a spring-loaded, curved piece of plastic in the back that seems to fit too lose. The shop said that I took it to ...

...part you'll see black pins, check if are they clean and embedded, if black pin in even a bit loose, you'r need to solder a new pin on the ...