Questions & Answers for: keep pilot light turned propane

Pilot goes out!! I installed a ProCom ML300TBA propane heater in my greenhouse. I am using a 7gal tank W/ inline regulator(regulator does not say what pressures it is preset to opererate at) and a 12"

...PILOT LIGHT. Probably air in the line. Keep at it. i vacuumed the line out, i taped the angle adapterso there was only a little bit showing and stuck it on the pilot hole for 3 minutes (I turned the ...

...pilot and keep it lit for 2 minutes than i go to turn it on and the pilot goes out. I have two of these and the other one works fine so i changed the thermopile that reads the flame and it still dose ...

...push down on red button to allow gas thru pilot tube hold down and light keep button held down for 1-2 mins while pilot is on to heat up the thermocoulple then release and turn knob to on

...pilot light jet. You should keep a lighted lighter at the jet so that when the gas arrives, the lighter will light it. After the pilot lights, you will have to keep the button pressed long enough for ...

...keep pilot button down then when turn knob to low pilot light goes off...could it be thermal coupler..? You got it!! The thermal coup need replaced. If you can take it out yourself do so and take it ...

...pilot light keeps blowing out tried resetting to no avail. If the pilot turns off after 30 minutes this could be the result of using butane.  On cold days it freezes, best to use propane for all ...

...down button light under where small silver line goes under while holding down button when lit keep holding for about a minute then turn to on should stay lit if wont stay lit need new pilot ...

...keep my shop warm. Your pilot flame should be blue with a small yellow tip, and it should cover the thermocouple (a small rod in front of the pilot light). If the flame is too small and doesn't cover ...

how turn on pilot on teledyne laars series 2 turn gas valve to pilot hold down for 1 minute keep holdibg and light pilot hold for 2 minutes then turn to on