...gear and install a new crush sleeve if you do it by the book, I have found that if the yoke is removed a new seal installed and the yoke tightened to about 50 foot lbs of torque it is ok, as far as ...
...heat and noise problems real fast. If all this checks you may want to look into a possible rack and pinion problem or maybe a steering gear. I would lubricate everything first though. Good
...gear tooth count exactly. That install can be done at home. there are many causes for rear diff noise. if fluid level is ok then you likely have a bad/worn set of gears or possibly bad/worn out ...
...Gear 1998 Explorer/Mountaineer Workshop Manual IN-VEHICLE REPAIR Rear Wheel Bearing and Axle Shaft Oil Seal -4.0L SOHC and 4.0L EI, Conventional Special Tool(s) Axle Seal Replacer T83T-1175-A Axle ...
...somewhere. The shop may have been talking about a seal on the rack and pinion gear, but if they knew there was a leak, they should have checked the steering gear for leaking when they had the
Usually answered in minutes!
2,998 Questions
2,307 Questions
2,248 Questions
2,302 Questions
1,513 Questions