just stopped working power to unit check power to bottom rear pcb.. if there is then pcb is most likely faulty
Hotpoint (and other named) models 'F07' means 'heater relay (possibly) stuck'. 'Check power supply connections to the heater, wiring and module (i.e. PCB) connections' (apparently poor PCB connections
Hotpoint (and other named) models 'F07' means 'heater relay (possibly) stuck'. 'Check power supply connections to the heater, wiring and module (i.e. PCB) connections' (apparently poor PCB connections
Question about Ultima WDM73 Front Load Washer / Dryer
Hotpoint (and other named) models there is a common problem often indicated by 'F08' which decodes as 'heater relay (possibly) stuck'. 'Check power supply connections to the heater, wiring and module
...Hotpoint WML540 wont start wash cycle. The door lock clicks 4 or 5 times then the red door lock light flashes. This sound like the main control board has blown and this is due to the motor shorting ...
...Hotpoint and Ariston) models 'F07' means 'heater relay (possibly) stuck'. 'Check power supply connections to the heater, wiring and module (i.e. PCB) connections' (apparently ...
Hotpoint and Ariston) models 'F08' means 'heater relay (possibly) stuck'. 'Check power supply connections to the heater, wiring and module (i.e. PCB) connections'. 'F02'
...Hotpoint and Ariston) models 'F07' means 'heater relay (possibly) stuck'. 'Check power supply connections to the heater, wiring and module (i.e. PCB) connections' (apparently ...
...Hotpoint and Ariston) models 'F08' means 'heater relay (possibly) stuck'. 'Check power supply connections to the heater, wiring and module (i.e. PCB) connections' (apparently ...
...with a meter, (165omhs aprox)Check the connection on the main power board J9 i thinkif all the above is ok you need a main pcb......hotpoint service engineer is the best way to go.hope this
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions
