Hayward pool heater - p5 code my hayward heatpro pool heater is displaying a P5 code. what does this mean? The code is "PS" for Pressure Switch and means there is insufficient pressure to operate (low
...PS, not P5, and it means the pressure switch is open. That unit will not fire until you resolve the pressure switch issue; either the flow is reduced too low and the pump/filter system needs to be ...
how to reset ps code on a hayward pool heater ps is pressure switch check switch and connections
Question about Aqua Logic PS-16 Automatic Controls 16 relays, 8 valves, 2 heater
hayward aqua plus control unit error code senor short bad temp sensor
Question about Aqua Logic PS-16 Automatic Controls 16 relays, 8 valves, 2 heater
How do I correct a "spa sensor open" fault? check system light is on and readout says spa sensor is open i came across that issue just three weeks ago. it turned out to be a frayed wire going into the
Question about Aqua Logic PS-16 Automatic Controls 16 relays, 8 valves, 2 heater
...hayward heatpro pool heater shows run light is on (orange), but there is no heat and the fan isn't turning on. It was showing PS until I replaced the pressure switch. But it still won't heat. After ...
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions