...fuser lamp does not come on, warm up is no completed Is there a diagnostic reset procedure for this machine dcp-7020 fail to warm - how do i reset if i turned off and on already and waited 10 minutes ...
Question about HL 1440 Laser Printer
...lamp to get extremly hot and burn out good luck One other thought is there could be marks from the stripper fingers at the fuser section look for build up of toner on them if so clean with q tip and ...
... in the fuser section u have a heater lamp and a thermister, either of thease could be bad. i would generaly go for the lamp. how ever the lamp can only be purchased through a authorized service ...
fuser i had at shop here. still melted rollers together Is the triac that controls on/off times of fuser lamp located on a pcb or by itself? I would wager that it is shorted to the always on condition
...fuser, it is a part in the back that runs at 180 deg cel via a lamp, the lamp blows causing no heat, no green light, long wait then error code. Fuser on one of these is not going to be worth having ...
...71 says the fuser unit is not installed, it means the fuser lamp is burned out, or the temp. sensors are bad. In either case the best repair is a new fuser which you'll find at ...
...the fuser has gone out, could be a dead lamp, or temperature sensors. Chances are you need a new fuser if you have 50,000 or more prints on this machine. www.precisionroller.com will have a new
...fuser error. Either the heater lamp is burned out, or one of the overtemp sensors has been tripped, or the power supply is not turning on the fuser. I would replace the fuser first if you have no way ...
Question about DCP-7020 All-In-One Laser Printer
...fuser lamp does not come on, warm up is no completed Is there a diagnostic reset procedure for this machine dcp-7020 fail to warm - how do i reset if i turned off . A reset is pointless. When a fuser ...
...fuser lamp is damaged, the fuser would need to be replaced, but bringing it in to an authorized brother service center would help. Its also possible its the LVPS (low voltage power supply) and ...
Usually answered in minutes!
1,135 Questions
1,072 Questions
1,012 Questions
767 Questions
733 Questions