...be replaced if there are no paper jams, then the most likely thing is the fuser ( where it come out) is not turning on and getting HOT) replace fuser ( not for the novice) scale of 1-10 this is a ...
...fuser (hot bit) Double check no paper is wraped around fuser rollers. These machines have a fuser at rear if you look at he fuser from the back, on it you will see, two thick fuser rollers (ones ...
...Odd time it also does it when it's only one page. Or the page comes out wrinkled - gets too hot and warps. your fuser my be damage on one part making the paper to stick to it check fuser thank ...
Question about X342n All-In-One Laser Printer
...on the hot roll which is the top roller on the fuser and is usually black or dark colored. if the fuser suffered a broken detake finger it could scratch the surface of the hot roll creating a hot ...
...area covering the hot parts so that you can open part of the fuser and peek inside. smudged copies means the toner is not being fully fused to the paper replace the fuser and your problem will go ...
...hot... im guessing the fuser lamp has blown.... is there any other reason you can think of for this fault? thanks Hi, Majorly this Error 920.X display for a cold fuser. Some 920.xx error codes may be ...
...fuser can be hot) 4. Pull the fuser straight up and out of the unit using handles on either end ot the fuser. (darker grey plastic) 5. Examine fuser for paper stuck in the rollers or sensors. Also ...
...fuser (hot bit) Double check no paper is wraped around fuser rollers. These machines have a fuser at rear if you look at he fuser from the back, on it you will see, two thick fuser rollers (ones ...
...fuser is actually getting hot, then it is likely the temp sensor. It looks like a mylar pad that should be rubbing (in direct contact) with the teflon roller (the hard grey one, not red rubber). The ...
...fuser pressure roller is out of round and the noise is the flat spot hitting the hot roller on every rotation. 2. These printers have an envelope mode that activates a solenoid in the fuser when ...
Usually answered in minutes!
1,487 Questions
1,353 Questions
1,277 Questions
961 Questions
741 Questions