Questions & Answers for: crank shaft timming belt pulley

...timming marks on a 1995 Geo Tracker with a vin code of 6 Have Spark and injector pulse, compression 150, Apparently engine code 6 is important http://carfix.stufftoread.com/ its on my page all how to ...

belt (not there) looks like it goes from crank pulley to pump pulley. My problem is I can't figure how to adjust the belt tension. Is there an idler pulley or tensioner missing? Thank You buggie@toast

...seals to the shoulder on the back of the pulley (harmonic balancer), not the crank shaft. Use a special pulley removal tool, NOT a hammer or crowbar to remove. Breaks easy and is expensive to

...crank position by turning the cam/belt when replacing the belt. You can slide the pulley back on withtout tightening it to double check your alignment marks before you button it all back up. Notch on ...

...am trying To Find where my timing marks should be ( belt broke ) most of the time there will be one mark on the crank pulley gear and the one on the cam pulley gear.usually a dot or a straight

...The crank shaft gear mark is at 12oclock. The cam sprocket is on the E mark at 12 o'clock. The distributor rotor should point to #4 at TDC. If not adjust

...crank bolt was under torqued, causing the lower timing belt cog to slip... damaging the keyway in the crank. For more info see one of the several Suzuki forums. (Your Tracker IS a rebadged

crank and cam postions 94 geo tracker 16v engine cam timing this is called, on the G16b 16v not 8v. easy old post , and common 60,000mile service question., see the false cam marks, avoid them !!! ...

...START AN ENGINE WITH A CRANK SHAFT SENSOR FROM A MANUAL TRANSMISSION INSTALLED IN A TRACKER WITH AN AUTOMATIC TRANSMISSION switch the ecm or brain from that vihicle to the other and thst should do ...

belt, spark plugs. Cam will turn but crank will not, placed in neutral still will not turn. Any suggestions please? 1995 Geo Tracker 1.6L 16 valve. Removed distributor, timing belt, plugs, valve cover