Questions & Answers for: Canon PowerShot ccd board

...is due to ccd chip failure or a board problem. If it is still under repair warranty, ship it back ASAP. A damaged electronic component for this model may be replaced by a trained tech only. Good

...The only problem is that it won't actually snap the picture. Memory card is in the camera and isn't full. Bad CCD or CCD circuit board. Try getting a quote for CCD repair or buy another used

CCD chip board needs to be replaced to remedy the problem. This model is not under advisory repair from the manufacturer so it will probably cost you for the repair. Canon was charging around $120-149

...a really weird picture Transfer the pictures to computer, if same thing on computer, the CCD or main PC board defected.If it?s good picture on computer, check the LCD for loose connection or

...CCD or the entire lens, but in particular this SD1000 camera the main board components can go wrong too. You can sell it "as is" on ebay for $50-70 and buy a working one for 80-90, the difference ...

CCD imager chip is loose and cannot get electricity. Thereby cannot send an image to the main board in the camera. This is similar to an antennae not being totally connected to a radio or tv, and when

...camera at any time, I would recommend that you take it to a camera repair shop, or sending it in to Canon. It sounds like the ribbon cable from the CCD or CMOS to the circuit board has

board, the ccd, or something came apart in the lens. Yes, it can be a few different reasons. A lot of people will blame that on the CCD Sensor but it's not always that. The best place to get help with

board got physical damage due to drop of camera. Visual check by qualified camera tech is needed to fix it. the could be the Backlight/CCD image going bad in the camera, if the output video is so dark

...board. However if the older images are seen well then the LCD is working correctly and the fault can be failure of the CCD- charge coupled device in the camera. If you have accidently exposed the ...