...blower and test to see if the dryer is still noisy. If it is, you probably need to replace it. How old is this dryer. Most likely you bearings have gone bad. CHECK THE FOR THE BROKEN BEARINGS, KINDLY ...
stuck a vaccuum down into it, or could the blower be getting weak after almost 5 years? I have seen the blower unit in those machines split where the impellor is fastened to the shaft. This causes the
...blower. Anyone got an idea how to switch back to vaccuum. My manual got wet and was pretty garbage. Unable to find a manual online. Check to see if the plastic ball is stuck . There should be a ball ...
Question about 584-06-00 Canister Wet/Dry Vacuum
the pull cord will not engage the flywheel. it pulls our with no resistance. The rewind ratchet drum has steel balls that engage, they could be stuck with old grease, take it off (reverse threads) and
...Any Ideas? Something is bound. See if you can turn the motor by hand with the belt off same with the drum. If the motor is stuck check the blower for a lint ball or another object stuck in it. ...
...blower? Also, will the vacuum still work without the filter nut attached to the plate? Please let me know at your earliest convenience. Thank you. Most wet dry vacs have a ball float that blocks the ...
...blower only blows threw the defrost vents. all climates everything, no matter where i put the control knob. dealership says the solenoid got stuck closed after using my 4 wheel drive. Assuming you ...
stuck inbetween the drum and the housing and scrape and grind making funny noises, things like coins, bra wire, nails, hair pins, etc sometimes u can just remove the cabinet and observe by turning the
Question about Cyber-shot DSC-RX100 II Digital Camera Essential Kit
stuck halfway open. Can I clean carefully with a Q-tip and alcohol? sir, you don't use any kind of liquid to clean the lens side, because it may flow inside of the lens,due to this the picture clarity
Question about Cyber-shot DSC-RX100 II Digital Camera Essential Kit
...stuck. I used a 1/4 inch socket extension and tapped on the piston and it came out and I cleaned up the brass tube and the piston works freely now. The problem is where do the wires go on the circuit ...
Usually answered in minutes!
1,743 Questions
1,329 Questions
1,410 Questions
1,123 Questions
940 Questions