...stereo receiver kr-596 I've had this item for about 10 years so i know its old but well taken care of, the first problem to occur was when i turned it on the on/off noise(click) would repeat over and ...
bad wire, mis-aligned, etc.) and that is causing the problem. Good luck. I have fixed a few of these problems approx 95% of the time the problem is a flex cable between the main unit & the face plate.
...stereo!! Hey, I've got this same model receiver and had the same problem. The faceplate would light up and everything worked, but there was nothing on the display. I read this similar post ...
...stereo does not have the "ACC" voltage. It could have blown a fuse. The "ACC" voltage goes to the red wire on the harness and you get that voltage turned on only when the ignition is turned on in the ...
...bad (multimeter showed no continuity even though solder joints were good). I could not order a resistor from Kenwood (no longer available) so I ordered some from Digi-Key corp (10 for $3.30 plus ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions