I just installed my 10 inch square pyle sub and its hooked up to the dub amplifier..the amplifier is in safe mode and the subs woint hit..what do i do to fix this?

Dual XPE1700 User Manual ' Page 7 / 12

Manuals Directory https://www.manualsdir.com > ... > XPE1700
Dual XPE1700 User Manual • Amplifier connections, Xpe series installation • Dual Car amplifier. ... load for the XPE2700 and XPE4700 ... Subwoofer (mono).

Dual Car Amplifier XPE2700 User Manual - Etronics

Manuals Online http://etronics.manualsonline.com > xpe2700 > page

Find product support and user manuals for your Dual Car Amplifier XPE2700, and save it to your ... Connect speaker wires observing ... Subwoofer (mono).

• 
  

  Dual Car Amplifier XPE2700 User Manual

  http://datavision.manualsonline.com > xpe2700 > page
  
  your particular installation. Subwoofer (mono). Typical Bridged Wiring. (4 ohms minimum). 2 Speakers (stereo). Typical Stereo Wiring.

Car Amplifier User Manual - Dual XPE2700

ManualShelf https://www.manualshelf.com > manual > car-amplifie...

XPE SERIES INSTALLATION Connection Descriptions NOTE Be sure to follow specific instructions included with your amplifier installation kit (not included ...

Wire it in a parallel instead of a series circuit

your amp should work with any cd player. the only way to make sure to get maximum wattage out of your subs, is to make sure that they are wired properly to get the correct impedance at your amp

+ to + but if your amp shuts off and turns on switch it to + to -

It sounds like the wiring either to the amp or to the subs is put together wrong. This can be because you have them setup in stereo but have the sub on bridge mode or vica versa. This can also be from how you ran the audio input wither from speakers or rca..either wired wrong or the switch for the two options is wrong. Also make sure your gain is turned up. Sound also depends on what kind of box it is in. It HAS to be in a box.

could it be as simple as bass boost??? maybe you have the subs hooked up wrong... have to have the ohms right.....hopefully this helped

if you have dual voice coils connect on each seporate sub negative left channel to possative right channel of the subwoofer same to other sub then conect the left possative and the right neggative to your box power terminal same to other sub then conect the two sub outs on your box left speaker positive to your positive left channel bridge then conect left speaker negative to the right speaker possative then connect your right speaker negative to your right channel negative brigdeg to your amp is single coil hook the box its self up the same way to your amp i have two dual voice cooil 12" hooked up to the same amp that way and it rocks without the power protecter turning on

If you power up the amp with the RCAs plugged in, does it go into protection mode.

If you power up the amp with the RCAs plugged in, does the woofer pop?

yep, they dont make audiobahn any more i think they still make other subs to one of them is DUB subs, ebay is the best place for me to find audiobahn, and for parts...

check to make sure your ground wire is attached to a clean metal surface no more then 18" away from amp. check all wires to ensure none are touching other terminal. all else fails remove one sub and see how it play, if its works great switch subs. could be a defective amp. if it is the amp and you payed for it with a credit card or bank card you can do a charge back from the bank to get your money back if the store wont replace it. thell the bank "you want to do a charge back cause it wasnt as discribed).