Onkyo - direct tv code for tx-ds 787

Unfortunately, the RC-771M remote doesn't control the TX-SR502. It will only work with these Onkyo models: TX-NR1008 and TX-NR808. The RC-567M is the one for the TX-SR502; replacement remotes that are exact replacements are still available from various places including Amazon.com .

Since the TX-SR502 was released in ~2004, that replacement remote probably won't control other devices that were released in 2004 or later. Onkyo changed its IR code programming before the TX-NR1008 was released in ~2010 and the RC-771M can't communicate with the older receiver. The manuals for the receivers listed above are still available from Onkyo on the product page under the Downloads tab.

I wish that I had better news for you.

Cindy Wells

Did you try to ask this question on the support forum from Onkyo? because I don't know what you mean with reset.
When a device is defect, there is no reset button, to repair it. Only what software is involved or settings in a memory that can lose settings when the power is down, can be "reset"
Onkyo USA Support Forum Index page

see if this link helps you out.
No power on Onkyo TX DS 787 Google Search

If you still have the direct tv remote you can make the onkyo learn the codes from the direct tv remote via the Learning mode on the Onkyo Remote.Consult the onkyo remote user manual on how to do this step by step.This applies to remotes that have the learning feature,not all remotes have this feature,consult the manual to see if your remote has this feature.Good Luck

A bateria interna do receiver Onkyo TX-DS747 . A um terminal da bateria corroeu e eu preciso de um substituto.

Sony TV codes for the Onkyo TX-SR605 are : 0000, 0650, 1100, 1167, 1300, 1505, & 1651.

Instructions for the Onkyo RC682M and more remote codes are available here. The Onkyo TX-SR605 manual is available here.

I hope that helps.

You should be able to get this directly from Onkyo. What is the problem tthat leads you to believe that the board needs to be replaced? Realize that the board could cost upwards of $100 or more.

Dan

Your onkyo receiver and remote controller only decodes 4 digit codes so what you have to do is to call the manufacturer of the remote controller it self and ask for the hexa decimal codes for their remote. They should provide it to you coz they're the ones responsible on doing that.

Hello, I am sorry about your issue. Your hook up should have nothing to do with the remote. You should get some functions like on/off, volume control. Thank you, Onkyo, USA

if you mean HDMI compatible, then no. There are no HDMI inputs/outputs on this receiver. Component is the best it has.