Pop spilled into car's dvd player about 1.5 months ago which I didn't realize. Now the DVD player won't ''****'' in the DVD. Thoughts? Help? If I can't fix it, who do I contact to fix it? I would think the dealership would be very pricey. Any help would be greatly appreciated!

No! when water enters it will rapidly corrode the ic pins and other critical parts, best to replace the player.

Well it might just be a little glitch with the dvd player to causse this problem so unplud the DVD
player from the wall outlit and let it stay unplugged for about 30 minutes to see if it fixed the problem and there is a small button on the rear of the dvd player that allows the disc's to pop out but you need a small flat head screwdriver to do that. Lastly if zero luck it will need to be repaired then. DOn't take it apart it could make thuings worse.

With the DVD player turned off(stand by), press:
TOP MENU
CLEAR
POWER

Choose option 2 and after option 4. Type:
12450 [press enter]
00000 - Then press enter and power off.

DVD will now be region Free.

or

1. Switch on the player
2; Pop open the CD compartment
3. Enter the following code (using the remote): 2812
4. Highlight the region
5. Change to 9 (for Multi-region) using the 'Enter' button
6. Hit 'Clear' to exit
7. Pop in a DVD and enjoy!

Hi,

THere was some problem, with the chat...I was not gettin gyour messages

1.Switch on the player
2; Pop open the CD compartment
3. Enter the following code (using the remote): 2812
4. Highlight the region
5. Change to 9 (for Multi-region) using the 'Enter' button
6. Hit 'Clear' to exit
7. Pop in a DVD and enjoy!
Switch on the player
2; Pop open the CD compartment
3. Enter the following code (using the remote): 2812
4. Highlight the region
5. Change to 9 (for Multi-region) using the 'Enter' button
6. Hit 'Clear' to exit
7. Pop in a DVD and enjoy!

THere was some problem, with the chat...I was not gettin gyour messages

Did you clean the lense with the alcohol? You might try again, also wipe away the residue.

If no dice, you might try to contact Polaroid to see if you can get it replaced/exchanged under warranty.

Hi,

Here are the steps in unlocking the regions for your DVD :

1. Switch on the player
2; Pop open the CD compartment
3. Enter the following code (using the remote): 2812
4. Highlight the region
5. Change to 9 (for Multi-region) using the 'Enter' button
6. Hit 'Clear' to exit
7. Pop in a DVD and enjoy!

Best Regards,
Dongkitz

The unlock method should work for DVD players bought in regions 1 (USA) and 3 (south East Asia)

You need to use a One4All Universal remote for regions 1 & 3

1. Switch on the player
2. Pop open the CD compartment
3. Enter the following code (using the remote): 2812
4. Highlight the region
5. Change to 9 (for Multi-region) using the 'Enter' button
6. Hit 'Clear' to exit

I can't say 100% but it sounds similar to the problem I had with the same model . The sleep mode in the on/off switch had gone bad and a new switch fixed the problem. It was about $42 to rtepair at my local electronics repair shop. Hope this helps.

there's a little button under the screen that turns the screen off when you shut the top look close and flip it till it comes on, they become stiff in some models and don't always pop up so with a little flip it should

Loud pop and smoke is what happens when capacitor blow off. These things happen. It doesn't mean product is dangerously defective. Faulty capacitor, or circuit board, or a power surge can cause this. If it's two months old, it's probably under manufacturer warranty, and you'd be able to get it fixed without any extra cost. Good luck.