Bosch SGI45E16GB Dishwasher - timer not counting down

Many owners of the Bosch dishwashers perceive h01 (h: 01) or h02 (h: 02) and other signs as an error. But in fact, this is not an error, and you accidentally got into the start-up timer menu (delayed start of washing dishes). In this case, h01 means that washing dishes will start exactly in 1 hour; if the display shows h02, then washing process will begin exactly in 2 hours. As a rule, in most models of dishwashers from Bosch, a delayed start can be set in the range from 1 to 24 hours.



Timer programming You can delay the start of the program in 1-hour steps up to 24 hours.

1. Close the door.
2. Switch on ON/OFF switch [1].
3. Press button [4] + until the digital display [9] jumps to h:01
4. Press [4] + or - button until the displayed time corresponds with your requirements.
5. Press START button [6], timer programming is activated.
6. To delete timer programming, press the [4] + or - button until h:00 is indicated on the digital display [9].

You can change your program selection at any time until the program starts.




FOR LINK https://bosch-dishwasher-errors.com/bosch-dishwasher-error-code-h01-h02/

The unit may have developed a leak underneath and it may have a bad heater element. Pull the unit forward and put towels behind it on the floor, tilt it back 45 degrees to drain the water, wipe up the excess and put it back in position. Test it.

Assuming you have verified water is actually getting to water valve, most likely water valve is the problem and needs replacing.

Bosch Dishwasher Error Codes How To Clear What To Check
The link above should explain more on how you can remove the error.
Thanks.

have a technician check it out as it may be a board problem
normally the fill level switch ,when the set water level is reached activates 2 things
it stops the water in and at the same time moves the program on to start the wash cycle
so it is either that switch or the program board

Do not use this appliance until you have check if it is one of the bosch dishwashers subject to a recall repair. Use the link below to check
http://www.repairaction.co.uk/bosch

Bosch Dishwasher Won't Count Down

Hello,
This video will help you fix your ouch dishwasher.



You can also purchaser a repair video here.
http://www.appliancerepairlesson.com

well its not baloney but it is cheesey. normally changing the module is the cure but it has to be programmed correctly. bosch has a recall so check it out and see because the recall is free and the tech is suppose to know how to program it. go to thermedor .com and get the #. i am a old bosch tech.

May be open circuit water valve. Appliance will go to error mode if water level has not reached a certain height after a preset time. Check coil continuity with a multi meter. Should be looking for about 200 ohms.