My stereo is asking 4 a code what do i do? - Car Audio & Video

you will have to call the dealer with the numbers from the rear of the stereo to get the right code.

Hi:
most radio security codes are only 4 digits, and must be entered using the preset buttons on your stereo. If you are properly entering the code in the manner that your ownwers manual says, then your next step is to stop by your dealership service area, and with the VIN number of your car, they can help you unlock your stereo. I hope you get help!

Try asking here for free advice+code check

www.ukbookshelf.co.uk

try asking here

www.ukbookshelf.co.uk

as they offer free advice and codes , especially for these Bosch radios fitted in Suzukis

call panasonic with the serial and they will supply you with the code ...but they will ask for some type of proof you own it .. legally a letter to them is enough

try this website

ukbookshelf.co.uk

Mention FixYa

The 4 digit code is to unlock the stereo if the stereo is asking for the code.
If your stereo is working fine then just ignore it but keep the code safe, if your battery ever gets disconected or you remove stereo and put it back in then you will need the code to unlock it again.

GO TO A STEREO REPAIR SHOP, SOME CAN RESET OR USE FACTORY MASTER CODE TO UNLOCK

contact on your car dEALER....and ask for you pass code or stereo code....:)

Underneath the unit, solder all the blobs (4 of them) and it should by pass the code. FixMyRadio dot Net