Chunghop E-T908 Does anyone have clear instructions on programming this remote for a TCL HD TV?

Question edited for clarity and 'ECA' to 'RCA'.

Better to buy a Remote made for that television. No programming and same buttons as the old one.

https://www.google.com/search?q=RCA++4288+LED+TV+replacement+remote

Have a read

https://www.fixya.com/support/r29872378-universal_remotes_no_facsimile_remote

Here are the codes if you wish to proceed with the Chinese Chunhop

• RCA TV 1000 , 1003 , 1004 , 1005 , 1006 , 1007 , 1019 , 1054 , 1055 , 1082 , 1096 , 1098 , 1099 , 1100 , 1101 , 1102 , 1103 , 1129 , 1179 ,1181 , 1188 , 1190 , 1196 , 1202 , 1203 , 1212 , 1215 , 1233 , 1257 , 1258 ,1266 , 1278 , 1279 , 1281 , 1286 , 1352

..

the button will be labeled either source, input, tv/video. if the direct TV remote was programmed for your television there is a tv/input button

Hello there,

Go to the Chunghop main site and find the remote you have by the image and then Download the manual in the manual it has all the codes that are pre-programed into the remote control if the code is not in the list use the Code Search and program the remote control .

Here is a link to the main site http://www.chunghop.com/en/products.asp

i hope this was helpful and don't forget to Rate

Hi,

The Mitsubishi TV codes for this remote are 011 and 051.

Programming instructions:

1. Switch on the TV
2. Press the "SET" button in the top-left corner of your Chunghop remote until the LED next to the "SET" button illuminates.
3. Enter the first code above 0 1 1 using the numerical buttons on the remote.

The LED next to the "SET" button will go out if you have correctly entered a code.

4. Test the remote with the TV. If it doesn't work - or doesn't operate the TV functions as you would expect - repeat the above steps for the other code.

Please note: Not all universal remotes will work with all TVs.

If the codes above don't work please post back for further assistance. It may be that your remote wont work with your TV or you may need to run the code search feature of the remote to find the correct code.

Hope this helps.

Regards,
BElectric

saan kami makakabili ng remotecontrol ng tcl tv

Go to www.chunghop.com/en/ for the answers.

If you don't have a code you can do these steps to get your universal remote working with pretty much any tv:

1.) Turn your TV on. Then on your remote press the set button, it's the small gray button above the green button that says TV.

2.) Press the TV button. There should be a red light to the right of the SET button. This means that your remote is ready for the TV code.

3.) To find the TV code, press the + or - on your remote. This is located above the orange buttons. Once the volume on your TV goes up or down, stop pressing the + or - button.

4.) Then press the SET button again to set that code for your TV.

If the above steps do not work, keep trying. It will work! ;)

most universal remote would work like this... press butons tv and power on at same time till red light of remote lights still. then press 110. then presto, it works... i hope i help in a way.

POLYTRON CODE PLS.?