Sportstake weekend tips

First try and get as much glue that is left in between the left over pencil and the tip out. Then find something that is the same diameter as the tip of the glue gun and about 6 inches longer that the length of the gun. With the glue gun OFF jam the object into the tip of the glue gun until it comes out the rear of the gun. Whatever you find to do this needs to be stiff like wire or something of the sort.

Your internet browser is remembering the name and password because at some point it asked if you wanted to save it and you said you did. Go into the Internet Options or Settings in your browser (Internet Explorer, Firefox, Chrome, or whatever one you're using) and look for the option to clear out the saved passwords.

Hi,
We need the OS of your computer so that we can give you the compatible driver for your laptop. Please provide these info first whenever you ask questions. Here are some links that you can try to install the audio driver that you are looking for. Good luck.
Realtek
Connexant

for the meantime please read through this tip so that you will be able to ask a more accurate question the next time.
Tip

sounds like the threads worn pop the screw in and with a pin head apply superglue otherwise take into any glasses shop and they should be able to help please give thumbs up thanks

Hi,

Check out these tips...they can help you figure out what is going wrong with your refrigerator and why it is not cooling

Refrigerator not Cooling or Fridge not Cooling

How to Defrost Refrigerator Defrost Timer Problem

Water Running in refrigerator from Freezer

Refrigerator or Freezer not Cooling or Getting Cold

heatman101

Hi,
The dark molasses is the old glue that is in the gun that was "cooked" I don't think the tool is burnt out. I would take a shot at pushing sticks into the gun while it is heated up until the glue that comes out of the tip turns clear. Then the gun should now be "cleaned"
Then unplug it, so that it cools down. After it is cooled , you will be able to remove the old dried up goo from around the tip so that it is completely clean.
WARNING: DO NOT IMMERSE THE GUN IN WATER
The gun is not really designed to be disassembled and cleaned.
The next time you use it, it should be fine.
Hope this helps,
Mark

Hello Alicia

Most often the wall plate will screw to the wall and then there is a set screw (usually an allen key) to tighten the fixture onto the wall plate. If it is the wall plate that won't stay on the wall then your screw holes are probably stripped. An easy way to fix this is to fill the hole with a wood glue filler available at your local hardware store. Use toothpicks to jam the filler into the hole. You can also use white wood glue and jam glue and toothpicks into the hole. Let it dry overnight and the next day you will be able to screw the plate back onto the wall. If the fixture is falling off the wall plate then the set screw is not being tightened hard enough against the plate to hold it onto the wall. Good luck with the repair.

if it is just a vent pipe and your sure that is what it is, you can acctually just sink two screws into the pipe. I would not use glue as it has a much lower flash point then the pvc. you could also see if there is enough flex in the pipe to just push it over.

possibly not... go to a technology place and ask for a repair. because glue might destroy the inside of your ds, making more damage