My emerson tablet wont let me take it off the charger

The battery is defective.

The battery pack is most likely failed

replace the rechargeable battery pack

Hi Patti, here's a quick link to troubleshooting steps to assist you with the spray.

http://www.bissell.com/FAQDetail.aspx?id=1123&cid=ccsocial

Make sure machine is set for regular zigzag stitch and not a fancy zigzag stitch, and rotate it by hand at least two full revolutions in the normal direction of rotation to make sure it is settled in to the regular zigzag stitch. Now set the stitch width to maximum width and slowly rotate it by hand, watching the needle. Does the needle strike the top of the foot at the extreme left or right? (and this is the slotted zigzag foot, right?) If not, you are good to go. If the needle does hit the top of the foot squarely, do make sure that the foot is mounted correctly and change the needle, making sure it is the correct size and that it is inserted all the way and facing the right direction. It is somewhat unlikely that the left to right position of the needle bar needs adjusting.

Scroll through this list the duel alarm with smart set will probably be simiular. Good luck. http://portablemedia.manualsonline.com/manuals/mfg/emerson/emerson_clock_radio_product_list.html

It could be that the belt is worn. You can get replacement belts and the manual here:

Bissell PowerFrorce Belts and Manual

CHARGER WONT WORK MEC B5265 CAN I BUY NEW ONE?

did you try plugging in 560 driectly to charger then run it?

Yes it has a belt. Could be the belt or a worn out brush roller, or you don't have the height adjustment set right. But I would check the belt first. It is the cheapest part and if you haven't changed it lately it probably needs it anyhow.

If you haven't changed the belt before it's a little tricky.

Turn the knob on the front to the belt off position, and unlatch the top of the nozzle to remove it. Pull the nozzle off and turn the knob to the belt on position. Take off the bottom plate and take out the old brush roller and belt. Pay special attention to how the roller comes out. You don't want to get it in backward.

Put the new belt on the roller and center it. Put the roller back into the nozzle and put the bottom plate back on. Turn the knob to the belt off position you should be able to see through the hole in the back, the hook pick up the belt and stretch in up.

Put the nozzle back on the unit, latch the top, and turn the knob to the belt on position. Simple Right? LOL

It has to be one of the most complicated machines to change a belt on .

P.S. they usually give you extra belt when you buy it, and the new style knurled belts work fine as well.

Good Luck-Don't be afraid to ask another question if that doesn't solve your problem.