Hp touchpad not working

Here you have a link that explains everything about HP touchpads http://h20565.www2.hp.com/hpsc/doc/public/display?sp4ts.oid=3356620&docId=emr_na-c01876141

I have also been facing this issue on my Hp Printer.
I am sharing a link, just go through the link below and resolve the issue on your own.
Not only HP Touchpad Sleep Of ***** Issue but resolve other issues of Hp Printer also.
Just visit the link:-
https://www.hptechnicalsupportphonenumber.com/blog/fix-hp-touchpad-sleep-*****-issue/

click on start control panel and click on mouse and touchpad settings it might be off.

Double click on pad surface. Buttons could be faulty. Check mousepad settings. Install drivers

go to control panel and mouse settings


adjust the sensitivity

then restart computer

let me know how this works

Touchpad zone is on upper left of the touchpad:

Turning the TouchPad on and off

The TouchPad is turned on at the factory. When the TouchPad zone is active, the light is off.
To turn the TouchPad on and off, quickly double-tap the TouchPad off indicator.

If I could be of further assistance, let me know. If this helps or solves the issue, please rate it and give a testimonial for my response.

Thanks, Joe


I’m happy to assist further over the phone at https://www.6ya.com/expert/joe_8b8c2cd6ce148309

Hi, it may be that your touchpad its turned off, HPs and Compaqs have a small button atop the touchpad to turn it on or off, this is for people who find it annoying when typing. If is not that it may the driver, you can find it in the hp site.

make sure it is turned on.

You will need to install the WIndows 7 drivers for your touchpad from HP. I have recently been on HP's site and find VERY few Win-7 drivers for any of the older machines.

Hi i am an ex HP employee

here are the steps

Remove the TouchPad Assembly

1. Remove the T8-9 mm screw that secures the TouchPad assembly to the base enclosure.
2. Turn the notebook right side up and open the display panel fully.
3. Lift the rear edge of the TouchPad assembly and remove it from the top cover.
4. Disconnect the TouchPad cable from the system board.
5. Remove the TouchPad assembly from the notebook.

Replace the the TouchPad Assembly

1. Place the TouchPad assembly over the palm rest.
2. Reconnect the TouchPad cable to the system board.
3. Toe the front edge of the TouchPad assembly into the top cover and lower the rear edge into position until it snaps into place.
4. Close the display panel and turn the notebook upside down.
5. Replace the T8-9 mm screw that secures the TouchPad assembly to the base enclosure.

I hope it works out