Reset access point motorola symbol ap 5131

George-

Contact Motorola Solutions

Get Support

Mark
Motorola Mobility Support

Yes you can use the two together but remember to set the AP6521 as a Access point.

Max number of clients in a AP5131 is 128

This is the reset username Username : reset Password:
MAC address XX XX XX XX 10 20 = IP address of 169.254.16.32 *10 in Hex = 16 in Dec *20 in Hex = 32 in Dec

Ideally, there shouldn't be any configuration needed. Access points are transparent and only work as a bridge between wireless and wired network so devices should obtain their IP info from your DHCP server not the access point by default.
If you face problems, then there might be a DHCP server in the access point, disable that.

good luck
Othman

Hi

You can set up the AP 5131 through Hyperterminal by accessing it through COM1 to start,
19200 bits per second
8 data bits
Parity: None
Stop bits: 1
Flow Control: None.

Good Luck. :)

Click the following link leave feedback if this helped.

Thanks B52Computers

http://support.symbol.com/support/browse.do?WidgetName=BROWSE_PRODUCT&TaxoName=SG_SupportGoals&BROWSE_PRODUCT.isProductTaxonomy=true&BROWSE_PRODUCT.NodeId=SG_AP_5131_1_2&BROWSE_PRODUCT.thisPageUrl=%2Fproduct%2Fproducts.do&id=m4&BROWSE_PRODUCT.TaxoName=SG_SupportGoals&NodeType=leaf&NodeName=AP5131&BROWSE_PRODUCT.NodeType=leaf&NodeId=SG_AP_5131_1_2&AppContext=AC_ProductPage&param_document=sp

exist 2 ways to do it...

first if you now te ip address and the user and password of admin, conect the ap at the ethernet port of you pc and configure it with a ip in the same range that the ap, put the ip direcction in the web browser.

the second way is conect the ap to the serial port and run the hyperterminal if you have windows, maybe you need configure the values of the conecctions.

1) Must be powered
2) Must use crossover cable
3) Connect to WAN port...

else, download the manual, get a serial cable, and connect to the console port using hyperterminal on 19200,8,none,1,no protocol...