How to fix error code E1 on my modeL SCEB Q.MR.12 beauty rest electric blanket.

Error code 021 on a Turboion Croc Classic flat iron indicates a problem with the temperature sensor. This error can prevent the flat iron from heating up properly and may cause it to shut off unexpectedly.
To fix this issue, you can try the following steps:

1. Turn off the flat iron and unplug it from the power outlet.
2. Use a small screwdriver to open the back cover of the flat iron and locate the temperature sensor.
3. Carefully inspect the temperature sensor for any signs of damage, such as bent or broken wires, loose connections, or burnt components.
4. If you notice any damage to the temperature sensor, you will need to replace it with a new one. You can purchase a replacement temperature sensor from Turboion or from a third-party supplier.
5. Once you have installed the new temperature sensor, reassemble the flat iron and plug it in. Turn it on and check if the error code 021 is still appearing.
6. If the error code persists, you may need to contact Turboion customer support for further assistance. They will be able to provide you with more detailed troubleshooting steps and help you resolve the issue.

Just remember that water and electric dont mix. In the intrest of your own safety throw it out and buy a new one. you cant do the same if you get a shock !

Did you get helped last year? If so please ignore. Otherwise....

Hi. You can locate a Sunbeam Service Centre via http://www.sunbeam.com.au/Pages/Support/Repairers.aspx

You're looking at $69,95 recommended retail.

BTW have you checked that it's not the blanket? Swap the controls over, if the problem follows the control it's the control. If the problem stays on the same side of the blanket, it's the blanket.

Also note Sunbeam has a 3 year warranty on electric blankets. If Date Of Purchase is less than 3 years ago call 1800025059 option 1 to speak to their Customer Service,

Return this product as it is a fire hazard.

please mark this as a fixya! thanks

I would definitely return this item. It has a short in it and could be hazardous.

pleasr mark this as a fixya! thanks

mydual control sunbeam electric blanket blinks on one control

"FF" or a blinking light will display meaning “Fault Found”. The “fault” is in the amount of power available to the blanket, mattress pad or throw.
There are several causes to this problem:
1. Bedding product is plugged into an extension cord, surge protector, power strip, or not plugged into a direct wall outlet.
2. Bedding product wasn't plugged in properly.

To FIX this problem, do the following to reset your bedding product:
1. Unplug the power cord from the electrical connection.
2. Unplug the cord from the actual bedding product itself.
3. Re-plug the cord into the bedding product. Make sure the connection is secure and complete.
4. Re-insert power cord back into a wall outlet.

If the 4 steps above are not followed in order, the bedding product will not properly reset.