The machine is operating in manual mode when the mode is shifted to auto there is no ecg trace on the display. Also when the ecg print is give on manual mode the machine switches off & gets restarted

Is there a "retrieve button"? Usually tracings are downloaded to disc after each EKG.

I would reset the machine to factory defaults. Leads to be printed can be manipulated but the factory setting is to print a full 12 lead.

settings-> system setup-> restore defaults-> yes -> hit start until you are back at the main screen and hit print again ( to get a print out)

If it still wont print all 12 leads call us: Discount Cardiology 800-507-8244

Hi,

- Go to the storage program by pressing "Shift" + "Store/retrieve" simultaneously.
- using the down arrow, move the cursor to the space where your ECG's are listed and underline the ECG you wish to re-print.
- Once the ECG is underlined, press "Shift" + "down arrow" simultaneously. Two little cursors will state that the ECG is selected.
- Press "Enter". The cursor will come back on top of the screen, on "Print".
- Press "Enter" again. The machine will start to print.

I hope this helps !

Fel

hi,
check the battery of your your ecg machine. if the buttery backup is not good this problem can occur.
also try to clean the paper sensor .
ok

hi,
When the at2 is in auto mode, first of all it check the leads are properly connected or not.Then it will acquire the ECG and store the same in its memory then only it starts printing. that's why it takes that much time to give a printout. When its starts printing you can remove the connections from the patient because it have already memorized the ECG.
If interpretation is in on position it will compare the acquired ecg with the standards in its memory (allready programed by the manufacturer). and will give a detailed report with ecg.
ok

hi,
u can make it single channel one by changing its setup. it will print single trace in the same paper. when u select this option it use more paper than the three trace.
ok

There is a process for cleaning the print head. Try that first. I did a quick read of the manual, and it appears filters CAN be adjusted, but I would regard that as a last resort solution.

Also, adjust trace height (mm/mV) and paper speed to spread out the trace.

I have a problem with ECG Schiller AT-1. In auto mode, it prints nothing but in manual mode it works properly. Could you help me solve this problem

Does it work in auto mode ? are you putting paper correctly means , there is a black mark on paper which is sensed by paper sensor .If you put paper up side down then paper sensor won't be able to sense any paper & gives you error for rifilling paper .If this doesn't help you then You need to replace battrey . Thanks

my machine now printed 2 paper in auto print mode, i want this print one paper .Can you help me solve this problem?
[email protected]