I have a GE Digia II dvr ditigal camera

Contact the manufacturer to get the default code setting

Just make sure that it is properly charged, if else make full charge and look for the battery Inserting place whether it has any rust on it. If so just scratch the rust and place the battery. If found the methods is not working then just call for particular brand and report the issue and confirm that whether you have any service center nearer to your location.
Source:- http://www.spy3k.be/PIR-Bewegingsmelder-Camera-met-SD-Opslag.html

First you need to be using Internet explorer as your browser as it does not support anything else.

Second, temporarly reduce your security settings in the browser. You may need to manually customize the setting rather than using the preset slider bar. Low/Medium/High etc.

The software is trying to install itself using active x but I believe the software is unsigned and will not install unless you reduce the security settings in the browser accordingly.

You will need to click the custom section, then find the box that says "download UNSIGNED activeX controls and chose the "PROMPT" setting. Hit apply, ok then restart the browser and try to log in to the DVR again.

Once the software installs on the machine and you are able to log in, reset the security setting back to the default levels. (THIS IS IMPORTANT)

DONT LEAVE THAT SETTING OR YOU MAY BE EXTREMELY VULNERABLE TO VIRUS, BROWSER ****** and TROJANS!!!!!!

I had exactly this issue and managed to resolve it by changing my monitor (i know, it sounds weird but i tried everything else).

My specific situation is that i am viewing the cameras across a Vmware View connection (essentially, fancy remote desktop). I think that the issue is somehow related to a DirectX / DirectDraw component not working correctly but i couldn't swear to it.The "fix" (i believe) cam when Windows 7 could readily identify the monitors by their model number rather than a "Generic Non-Plug & Play Monitor" like the original monitors were (I swapped out some old Dell 18" screens for sme shiny new Dell 22" ones).

Hope that helps point you in a useful direction.

Go to: Controlpanel -> Internet Options -> Security (tab)... Chose ''internet'' and press the ''Costum levle'' button.. Set alle ''active X controls to ''(not secure)'' and press ok, and apply.. UNDO THESE SETTING ONES U HAVE INSTALLED THE ACTIVE X ADDON, FOR YOUR ONE SAFTY!

Download the user manual:
http://www.gesecurity.com/portal/GESDownload?ID=6&DID=6&documenttype=User%20Manual


The default admin passcode is 4444 and the default user passcode is 1234

Try removing the plugin and reinstall if it is there. It is possible the plugin did not install properly or it was blocked by security settings. You may have to lower security settings temporarily while you install and may have to enable active x settings.

pull battery and let stand for about 5 min and reinstall battery and your good to go. This will reset whole unit.

I can't access via browser to the Digia II because appears the message: 'Please check the Digia2.ocx installation. Current version is 1.0.0.61.I'm using Internet Expplorer SP2

access the router look for portforwarding and enable port forwarding assign a name to your camera
type in the port your camera use. ex 593
then type the assign IP for your camera ex 192.168.1.6

to access it type in your browser the your public IP ex. 209.45.0.0:593
read your ip cam manual for accesing it.