Help with programming software

You should probably select ZPL, but that depends on which program you will use together with the printer.

Hi.Click this website http://welcome.solutions.brother.com/bsc/public/us/us/en/dlf/download_top.html?reg=us&c=us&lang=en&prod=mfc240c_allJust select your operating system ,language and search to get compatible software and driver.Hope can help you,Regards.

Hi deejaynickos
Try this :
Delete driver/software . Disconnect printer .
Download new english driver/software from http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?prodNameId=1140778&lang=en&cc=us&prodTypeId=18972&prodSeriesId=1140783&taskId=135
Make sure you ' ve selected the compatible OS and complete software .
Reboot , install downloaded software and connect the printer . Wait untill full operation is successfull .
regards ,
fanaudi .

This printer uses the first version of the HP PCL (Printer Communication Language) driver. HP is at this stage at PCL6, I am not entirely sure if it is backwards compatable.

Do you know if you are using a label software program to design the label or just ZPL (which is Zebra Programming Language) code direct to the printer? If it is software, then you can open that label design software file and remove the barcode. If it is ZPL, then you need to remove it from the code. I can help with this if you can email me the code.

[email protected]

Here is a step-to-step how to change it:
http://h10025.www1.hp.com/ewfrf/wc/document?docname=c01442897&cc=us&lc=en&dlc=en&product=3645100

Good luck
Please take a moment and rate my help for you

Nic

http://software.canon-europe.com/products/0010104.asp


Cick on the English Tab otherwise you will get every program in every language, just qiute alot to search though.

Hope that helps

Normal 0 You have to reinstall the CD software program that came with the printer. During installation you will be asked what language and then select ENGLISH. Then follow the instructions.
But first do this.
Disconnect the printer or at least be sure it is turned off. I'd do both and reinstall the CD software program that came with the printer. When the software program asks you to connect the printer to the USB port, do so and it should again work properly.
Hope this helps. Bud

Which site did you go to to get the drivers?
The Canon site i found asked you to specify which operating system and which language you wanted it in.
http://software.canon-europe.com/products/0010392.asp
I don't know of a setting to change to get it to install properly.
Trying going to this site and specifying language and let me know how it goes. I'll keep trying to help till we can solve this.
Good Luck.

small test... Hit the Go button 3 times, fairly fast like tick-tick-tick, normally by doing this the printer will print it's internal configuration pages. Are these in Swedish as well?

If I'm correct you selected the wrong supported language when installing the printer.

Go to your controll panel, remove the printer driver in "printers and faxes" as well as any brother software in "add/remove programs".
Then disconnect and reconnect the printer, install the driver and try to select the proper language while doing this.