Electric Fan - Black and Decker Typhoon Stand Fan

Pls help locate ASIMO electric fan service center in Manila. I need control board parts.

Thanks and brgds.

I searched for replacement beaters for Blacker & Decker SM-100 type 1 (SM100) electric stand mixer for years. I found the Sunbeam Mixmaster Mixer Replacement Beaters for stand mixers, item 4955, at a large Ace hardware store. They were priced over $16.00, so you may consider buying a new stand mixer. The beaters are the correct length, snap in and grip correctly even though the ends are curved like a half ball rather than flat as the originals. The beaters turns well but I haven't tested them with the bowl because I need to find the turn table that I have in storage. The beater set was design ed to replace parts for Sunbeam stand models 2355-1, 2356-1 and 2360-2.

when you turn TV on, watch to see if the Lamp Fan is running,if it stops when Lamp trys to light then set will not come on.which then means Lamp Fan is defective.

How to clean the blades in padestal fan i.e. remove the frame on blades.

There is a tip over switch that may have been placed upside down. check wiring

Check the power board

FAN AND LIGHT DOES NOT WORK
my zephyr typhoon stopped working. Neither light not the fan come up. I am sure there is power going into the unit. I turned on the light one day , the light cam on and suddenly went away. From then even the fan stopped working. any information on what happened is appreciated. Thanks

I work for Black and Decker customer support. Our customer service phone number is 1-800-231-9786.

If the unit isn't heating, it needs to be replaced. Unfortunately, the unit can't be repaired. The unit comes with a one year warranty from the date of purchase. Please call the number above so that we can determine your warranty eligibility and help you in any way that we can.

While this doesn't actually solve your problem, I hope the information allows you to make an informed decision as to how to proceed from here. Please let me know if I can be of further assistance.

An electric motor shop may be able to rebuild the motor for you, or you may be able to find a motor with the same ratings. Chances are this would be pricier than a new fan though.

first you have to remove the two plugs on top behind the buttons remove the two screws next you have to remove the base stand and their is one screw you have to remove then you can remove the front cover and you can get to the motor and fan.