Black & Decker Food Mixers - Recent Questions, Troubleshooting & Support
I have a black and
I find no current sources for that battery pack.
41B030AC18301 9724
I believe this is a two cell lithium assembly for 2.4V. If your handy and can open the pack without damage it may be possible to get replacement cells and rebuild the pack.
Need beaters for a black and decker SM100 mixer
I searched for replacement beaters for Blacker & Decker SM-100 type 1 (SM100) electric stand mixer for years. I found the Sunbeam Mixmaster Mixer Replacement Beaters for stand mixers, item 4955, at a large Ace hardware store. They were priced over $16.00, so you may consider buying a new stand mixer. The beaters are the correct length, snap in and grip correctly even though the ends are curved like a half ball rather than flat as the originals. The beaters turns well but I haven't tested them with the bowl because I need to find the turn table that I have in storage. The beater set was design ed to replace parts for Sunbeam stand models 2355-1, 2356-1 and 2360-2.
Need replacement beaters for model 106708
First I would check the yellow pages or my chamber of commerce
for a reputable dealer or repair station. If that doesn't work, try
https://www.ereplacementparts.com
Nylon gears stripped on hand mixer beater gears
Unfortunately, modern small appliances are considered "disposable" by the industry. So there are no "better made" parts. The best you can hope for are the same as what was originally installed. Try https://www.ereplacementparts.com
Need replacement beaters for B&D MX95
First I would search the yellow pages or call my chamber of commerce for a dealer or reputable repair shop. If that doesn't work, try https://www.ereplacementparts.com
How do you place beaters in mixer without them falling out?
I can't find a manual for the MX55 online, Suzanne, but looking at the picture of it I found on Amazon and based on the manuals for other B&D models, it looks like you should have two slightly different beaters: one with a collar and one without and it's very important that each beater go into the correct hole. The one with the collar should go into the left hole (looking at the bottom with the holes at the top) and the one without a collar into the right. The other manuals say "insert each beater and, if necessary, turn it slightly until it locks into place." I hope this helps. Good luck!
Not finding what you are looking for?
