My power source is gone out where can i get it fix and how much

Parts to fix will cost more than a new LCD and will use a lot less power.

*** Fix your HP Photosmart D7360 (Reset Code/Master Reset) ***

1- Turn off power and unplug from power source.
2- Open right side of printer (looking at the front).
3- Disconnect,by pulling gently, both white flat ribbon cables off the main circuit board.
4- Plug in power source and turn printer on. Wait till you get a error message and push "Ok".
5- Unplug power source.
6- Reconnect the flat ribbon cables by aligning and carefully pushing into the conectors on the main circuit board.
7- Plug in power source and turn printer on (Printer preparing occurred).
8- voila, the nasty error message 0xc18a0001 "Ink System has Failed" is now gone.

Contact hot point or kenmore. Often times there are cross reference parts that will work. This freezer is not much more than 7-8 years Los.

Possibly internal fuse or thermal cut out gone. perhaps best to have checked by Technician.....Check your power source is okay first...

Did you get this fixed?Please let me know.Thank You very much!

Tyler

even though it's only used moderately the motor can go out,
does the light come on?
try plugging the sewing machine into a different outlet
check to make sure the power cord is pushed all the way in
it also may be the power cord itself that has gone out
it could also be the on & off switch

These models are known for this issue.
I've had my share in the shop here.
Disconnect all speakers,turn speakers off, try headphones only
If it still persists then there is either :
1. power supply capacitors gone bad or 2. The thermal fuse in the transformer is open.
A tech can very easily find out if the thermal fuse is open by checking the primary of the transformer
if the plastic is shrinking away from the power supply capacitors then they've gone bad

Food for thought: I had a buzzing that affected only one analog source and it was associated with my track lighting being on. They told me the fader was defective so I replaced it. It was still there but it has since gone dormant and I don't know why. Just the same, I avoid using the track lighting if I'm listening to anything.

The inverter baord is easy to replace, you can get most of them here if you can get the number as printed on the board, see this site: http://www.lcdparts.net/DI3D.aspx

http://www.lcdparts.net/howto/Instruction/IInverterDetail.aspx?Model=VX900

check ur smps and power connector Mother board ok
next power switch for on/off ok check front panel byy