I will be using this Bunn frozen drink machine for the first time. It's at our neighborhood clubhouse. Can you advise the process? Can I make my own Margarita mix or Strawberry daiquiri mix. What proportions? How much time should I allow. What are the control buttons I should push. It's a Bunn double container with an auger in each section. Thanks

drink o matic power cord Questions & Answers - Fixya

www.fixya.com > Forum > Tags

Get free help, tips & support from top experts on drink o matic power cord related issues. ... the drink o matic? the green light wont turn on on the back. the fan wontturn ... stopped working Hi, I have a Smart Planet Drink-O-Matic model # DR3. ... The machine does not cool. ... I have the same machine, my power supply was .

[PDF]UNIT 5 TROUBLESHOOTING - Bunn

www.bunn.com/.../troubleshooting.pdf

Bunn?o?Matic CorporationGiven a realistic scenario when product does not freeze or chill, the learner will be able to ... The learner will be able troubleshoot the torque (ice) system.Missing: sharper ‎image ‎green

[PDF]Operating, Service, CDS-2, CDS-3 Operating ... - Bunn

www.bunn.com/sites/.../27646.0000.pdf

Bunn?o?Matic CorporationTo obtain the Illustrated Parts Catalog, visit the Bunn-O-Matic website, at www.bunn.com. .... In no event shall Bunn be liable for any other damage or loss, including,but not limited ... NOTE - Bunn-O-Matic does not recommend the use of any extension cord .... THREE QUICK FLASHES - Low auger torque is being sensed.Missing: sharper ‎image ‎my

Free Kitchen Appliance User Manuals ' ManualsOnline.com

kitchen.manualsonline.com/

Lift it up from the hole at the bottom and off of the shaft

Lift it up from the hole at the bottom and off of the shaft

Go to page 19 in this repair manual and follow the flow chart to see what is wrong with it and how to troubleshoot it. http://www.bunn.com/pdfs/manuals/41084.0000.pdf

remove the back cowling and blow off the sensor with canned air. usually dusty

the brix level (syrup to water ratio) may be too low, which will cause it to ice too quickly and cause damage.

in order for the product to slush, it has to be at the right brix level (syrup to water ratio). if it's too lean, it will ice up causing damage. there are also silicon seals that will not do well with carbonation after a while.

the sensor is inside the rear cowling and in the tube at the top behind the thermal wrap (black putty). pull it out and replace. you'll need to contact bunn for parts

Can go to the Bunn website.Go to commercial section,then manual index and then specialty drinks.You can find :Illustrated parts,operating service,service,repair and programming.