THis fuse is not exactly like the original, the original had resitor code values on it, anyways put it half way back together now I heard a click or either just the caps charging up, then connected the jack for the indicator lights, now I have a flashing yellow light on the lamp status LED, As far as I can recall this is the first time I have seen it flash before the fuse blew I know that the light was yellow/orange for about 5 months but never flashing or red, My question now is should I invest the $200 on a replacment lamp? Any advise guys?
SOURCE: Mitsubishi WD-62525 Red Status Light After Cap Replacement
which caps did you replace? As the normal repair for the first generation dlp is to replace the (4) 1000 uf caps. the (2) 2200 uf caps and the (2) 3300uf caps on the power pwb when you get the 34 error code.
SOURCE: Mitsubishi WD-62525 Red Status Light After Cap Replacement
Mitsubishi V26 error code 41 with solid red status indicator is caused by leakage from capacitors C9A37 and C9A38 (3300mf/16v). The result is a bad fuse F9A02 (15amp pico) which reports error code 41 indicating short protect. The Mits part number is 283P144040 but any PICO 15a fuse will work.
Bill W.
Integrityhomeworx.com
105 views
Usually answered in minutes!
I shouold clarify the noise I heard was definetely a relay closing not the sound of an electrical problem, I plugged it in still has the flashing yel/orange lamp status light. pressed the reset went back to the flashing lamp status light, no green pwr lights prestent no timer lights on either.
I have the same problem. The status light is just flashing as soon as I plug in the TV. Won't do anything else.
×