20 Most Recent
Jensen's VM9312 Car DVD Player - Page 6 Questions & Answers
Where does the remote wire hook up at
That goes to the remote turn-on terminal on an amplifier if you have one. That way when you turn on the head unit, the amp is powered up as well. If you don't have an amp, wrap any exposed wiring in that wire with electrical tape and tie it off - you won't need it.
Do you know the bypass for this radio vm9312
You can try the procedure for the VM9311TS model (the one I have) - I
don't know if it'll work but it's worth trying. Put in a DVD, and let
it start playing. Then hit STOP on the remote twice, and enter the code
1264. If you were able to see the actual movie
at this point, you'd see a menu pop up. Push down twice, then ENTER. At
this point the blue screen should clear and you should see the movie
itself. You'll have other options on that menu, like a macrovision
option to allow you to see burned DVDs. Set what you like, then on the remote, hit SYS SETUP twice to lock in your choices.
Have a jensen linear phase car receiver , there is
The pink wire is the safety wire so that you can not watch the screen (during a video) unless your car is in park. You can either connect it to a ground or completely bypass it by typing the code 543210 in the menu screen and turning the safety feature off.
Volume
Set the volume to the desired start up volume then hold the knob in for about thirty seconds. It should beep. The radio will then start at that volume everytime you start your car.
I have a jenson vm9312
Hi holister,
You are right there, very close.
The constant +12VDC goes to the Battery (or similar unswitched power source)
The Ignition wire needs to be run to your fuse box.
On the fuse box/panel you will see at least one male spade connector (flat) that says 'IGN'. This connector has +12VDC only with the ignition on.
Thats where it needs to go.
That's it buddy, enjoy the new tunes
Mike
E brake wiring problem no video
Do this, and don't worry about the parking break wire.
The parking brake bypass procedure is as follows:
1: Go into AM/FM mode
2: Hit "setup" on the remote control
3: Enter 543210 on the remote, listening for the beep for each number entered
4: A new menu will appear. Touch the button that has the hammer/screwdriver on it in the upper left-hand part of the screen.
5: Select Brake bypass to "ON" and hit the "X" near the bottom of the screen.
6: Use the unit wisely and above all safely. A ticket is one thing, causing a fatal accident due to negligence is another.
Where to wire the e brake so i can have video
Use the parking break bypass procedure, and there is no need to even hook up the break wire.
The parking brake bypass procedure is as follows:
1: Go into AM/FM mode
2: Hit "setup" on the remote control
3: Enter 543210 on the remote, listening for the beep for each number entered
4: A new menu will appear. Touch the button that has the hammer/screwdriver on it in the upper left-hand part of the screen.
5: Select Brake bypass to "ON" and hit the "X" near the bottom of the screen.
6: Use the unit wisely and above all safely. A ticket is one thing, causing a fatal accident due to negligence is another.
Not finding what you are looking for?