20 Most Recent
Maytag MDE9700AYW Neptune 174 Electric Dryer - Page 3 Questions & Answers
I have a Maytag Neptune Dryer that won't heat. we
First unplug dryer and test your heating element for continuity with a multimeter if it has more than about 30ohms it is bad.Next check for 220v-240v at the heating element with the dryer running (This is not a test for an amateur. If you are not familiar with electricity I would recommend calling a service tech. If you have 220v-240v there and no heat the heating element is most likely bad. If not then trace the wires back to find the open circuit could be a thermostat or the thermal fuse or just a loose wire/bad connection.
8/13/2013 3:41:33 PM •
Maytag...
•
Answered
on Aug 13, 2013
No heat
Possible failure of the element, fault in the wiring harness or connector or failure of the control panel or output.click on :
element
1/25/2013 6:21:29 AM •
Maytag...
•
Answered
on Jan 25, 2013
Scraping sound during dryer operation
There is probably a screw or the like stuck in one of the venting holes of the drum. Use a flashlight, eyes and ears to locate offending object. Needle nose pliers usually work best to remove.
12/31/2012 3:22:00 AM •
Maytag...
•
Answered
on Dec 31, 2012
My maytag neptune front load dryer model #MDE9700AYW shows a T5 code and will not heat.
Check to see if your thermistor is bad by measure the resistance. It should be 10K Ohms at room temperature. If it's bad, replace it BUT you have to CLEAR to error code. 1. Enter to Service Mode by press CHIME and TEMPERATURE keys for 3 seconds or until 3 beeps are heard. 2. Access Diagnostic Codes by pressing WRINKLE PREVENT. A d will be displayed. Rotate the CYCLE SELECTOR KNOB in either direction to read it. 3. Press SENSOR DRY and TIME keys for 3 seconds to clear it. 4. Power OFF to exit Service Mode 5. Power ON
11/13/2012 12:57:52 PM •
Maytag...
•
Answered
on Nov 13, 2012
Maytag neptune error message e5
This normally indicates that the thermistor is bad. Try measuring it to prove it is OK. It should be 10K Ohms at room temperature (20C / 68F).If necessary, replace it then clear the error code.1. Enter to Service Mode by press CHIME and TEMPERATURE keys for 3 seconds or until 3 beeps are heard.2. Access Diagnostic Codes by pressing WRINKLE PREVENT. A d will be displayed. Rotate the CYCLE SELECTOR KNOB in either direction to read it.3. Press SENSOR DRY and TIME keys for 3 seconds to clear it.4. Power OFF to exit Service Mode5. Power ON
9/8/2012 8:06:19 PM •
Maytag...
•
Answered
on Sep 08, 2012
Not finding what you are looking for?