20 Most Recent
Frigidaire FAH106N1 Wall/Window Air Conditioner - Page 9 Questions & Answers
WHAT IS ERROR CODE H5 FOR A FRIGIDAIRE HEAT/COOL WINDOW UNIT?
Thank you for your inquiry, Angela Babin!
From my understanding your Frigidaire air conditioner is displaying an error code "H5". Normally, the error code "H5" stands for heater thermistor error. I would recommend performing a reset on your air conditioner by unplugging it for ten minutes. If that does not help correct the error code it could be a possible problem with your thermistor or control board. I hope this is helpfully. -Matt
I have an air/heat window unit that wont heat good and wont let me change fan speeds what can be the cause
Hello friend, thank you for your post!
Based off the information you have provided your Frigidaire air conditioner, FAZ08HS1A, is not heating up or changing fan speeds. From what you are describing it sounds like a potential problem with the control board or sensor. I would suggest performing a reset on your air conditioner and you can do that by disconnecting power from it for ten minutes. Are you under warranty? I would consult with the manufacturer for further resolution regarding your air conditioner. I hope this information has been helpful. -Matt
Where is there a drain hole for the water?
Your Frigidaire window unit is the same as any other window unit. Typically window unit air conditioners don't have a drain. This is why you have to make sure the back of the unit (the end that goes outside) is slightly lower than the front when you put it in a window. When it gets so high with water it drains out the back onto the ground.
What year was this model made?
Your unit (B3BV-036K-BB) is a Westinghouse / Nordyne Unit.
Vertical Flow only, 36,000 BTU, 208/230 volts.
You cannot tell the manufacture date from a model number, only from the serial number. Try contacting manufacture with the serial number...
(nordyne.com)
What is the starfoam for in my airconditionar for?
Hey friend, thanks for your inquiry!
The sytrofoam inside the air conditioner is part of the duct work and it also helps to hold colder temperatures. The new air conditioners do not have drain holes but instead recycle the water inside your appliance to help cool the internal components. I hope this information is helpful. -Matt
I have a frigidaire fra123cv1 every 3minutes it
Good morning jesse dixon, I appreciate your post!
Based off the information you have provided your Frigidaire air conditioner, FRA123CV1, cutting off every three minutes and then flashes "#88" then it will go back to the normal setting. Sounds it could be a possible issue within your control panel or power cord. Are you currently under warranty? If so, you might want to reach out directly to the manufacturer to determine the coverage on your air conditioner and the procedures to any potential remedy. I hope this helps to some degree. -Matt
Why is my Frigidaire 18,000 BTU A/C (FAM186R2A2) not coming on?
Hey friend, thank you for your inquiry!
I see you have recently changed the PC board inside of your Frigidaire air conditioner, FAM186R2A2, and now your appliance will not come on. It sounds like you could be having a potential issue within your power cord or another issue within that board. I would recommend having a professional come out to diagnose your appliance to avoid any further unnecessary part purchases. Hopefully this is helpful. -Matt
Why does it starts up then shuts off and all the lights start blinking
Hey friend, I appreciate your post!
I see that your Frigidaire air conditioner will start up then shut off and blink. It could possibly an issue with control panel or the power source of the appliance. I would attempt to perform a reset on the air conditioner which would be removing the plug and pressing the "Test" button, you will hear a click and the button will pop out. Then press the "Reset" button, you will hear another click then plug the appliance in. Those are the steps to resetting your air conditioner, if that does not successfully correct the problem please reply back. I look forward to your response. -Matt
Sleep will not turn off
Hello Friend, this is Z. I appreciate your post!
From what you have described, it appears that your air conditioner may possibly be experiencing a communication problem with the control board or a potential wiring failure. Since you have already tried resetting your air conditioner, at this point I recommend reaching out to a professional to properly diagnose and repair your appliance.
What is os code
Good Morning Friend, thank you for question!
I see that your post is listed under Frigidaire air conditioners and that you are receiving an error code OS. In order to better assist you, I would need your model number please. The serial tag, which lists your model number, is typically located behind the front grill by the air outlet or on the inside of the cabinet. Other possible
locations for the tag on a
room air conditioner is on the front edge of the chassis base or behind the dial plate of the
control panel. If you have a
split air conditioner, try checking on either the front or outer appliance on the right side of the cabinet. Thank you and I look forward to your response! - Z
How do i empty the drain bucket
Good Morning Friend, this is Z. Thank you for your post!
I see that your question is listed under Frigidaire air conditioner and you are inquiring about how to empty the drain bucket. However based on the picture of the model (split-air conditioner) shown above. I do not see it has a drain bucket. May I have your model number please? You can normally find the serial tag (which lists your model number) on the right side of the cabinet on both the inside and outside appliance. With this information I can better address the issue at hand. Thank you!
Where is the button to reset on a frigidaire air conditioner
Hi friend, that's a great question!
To reset your Frigidaire air conditioner you would need to make sure the appliance is turned off and unplugged. On the power cord you will see a test button, push that button and you will hear a click. You would then press the reset button you will hear a click again signifying that the appliance has been reset. Then plug your air conditioner back in and it should be reset. -Matt
My portable air conditioner won't cool.
First determine if the pump/compressor is working. If not, there's your problem. Needs repair done by a shop. Well, really, only a shop should be repairing Ac units due to certificatios,equipment and EPA refrigerant recovery regulations. Sorry. -Ned_
What type of freon 5695
Hello Friend, this is Z. Thank you for your post!
I understand that your inquiry is listed under Frigidaire Air Conditioner and that you would like to know what type of Freon 5695 is. You may typically locate information regarding the Freon on the serial tag (which lists your model number) of your air conditioner. You can normally find the serial tag behind the front grill by the air outlet or on the inside of the cabinet. Hope this helps!
A/C unit does not blow cold air
Good Morning Friend,
I understand your Frigidaire air conditioner, model# FAA055P7A1, is not blowing cold air. I also see that you have had it in storage and it has not been run for 5 seasons. Please note that the "Cool " circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time.
First, make sure you have cleaned the filter by following these instructions:
• Push the vent handle to the Vent Closed position (where applicable).
• Open the front panel.
• Grasp the filter by the center and pull up and out.
• Wash the filter using liquid dishwashing detergent and warm water. Rinse filter thoroughly. Gently shake excess water from the filter. Be sure filter is thoroughly dry before replacing.
• Or, instead of washing you may vacuum the filter clean.
Secondly, make sure the temperature sensing element, located behind the air filter, is not touching a cold coil. If it is straighten it away from the coil.
Lastly, try resetting your air conditioner to a lower temperature.
I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your appliances status has changed successfully. Hope this is helpful.
-Best Regards-
WP
My unit powers on but no air blows out
Good Afternoon Friend,
I understand that your Frigidaire air conditioner, model# FAC126P1A3, will power on, but no air is blowing out. I suggest contacting the manufacturer. They will be able to point you in the right direction of having your air conditioner functioning correctly. Hope this is helpful.
-Best Regards-
WP
Not finding what you are looking for?