20 Most Recent HP DeskJet 3745 Printer - Page 7 Questions & Answers

dear friend,
these are basic steps to install your printer.
1) you need a printer driver cd or driver setup file.
2) run your setup file and follow the steps
3) while your setup is running connect your printer with your computer and give them power.
4) after installation is complete restart your system.
5) done.
u r ready for give print

cartiridge error .clean the circuit of cartidges.........no use then replace cartidges

Remove the cartridges from the printer and clean the copper contacts on the cartridges with a lint free clean cloth and distilled water, open the cartridges access door and unplug the power cable from the printer while it is ON, clean the copper contacts on the printer where the cartridges contacts touches it and then plug the cord back , insert the cartridges and align , check the results.

If this does not work, Here are the steps for reset, if it still won't work, then service the printer and repalce it frm HP if in warranty.
Unplug the power cable from the printer and press and hold power and cancel buttons and plug the cord back and then check the results after turning off and ON, make sure the cartridges are out when you do this.

clean your cartridge sensor with iso propyle or little water on a cotton if,,,,,,,,, or might be your printer cartridge carriage is faulty.......... and after last thing is your printer card ............. then take your printer to any local repair center

Thanks please keep updated. please do rate the solution positively .Thank you for using Fixya

Regards
Manish

Alternative driver download link: HP Deskjet 3745 Printer Driver

A1288

Hi There

Summary

Usage of compatible ink and leave the printer idle too long may cause printhead clogging
What should you do if you get this problem. Relax; you may recover the printhead by unclogging it. Follow these steps to unclog the printhead

1. Right click in the printer driver name
2. Select Properties menu
3. Click Maintenance tab
4. Click on cleaning sign for regular cleaning. Perform this up to 3 times.
5. If this does not work, perform Deep Cleaning

And if that not work

Some times it needs a good clean up but this is up to you if you want to do this,
But after you done this prime the printer so it gets the inks back in the heads, it may take a little time for the inks to work.

Ok.

There is fluid cleaner for this but I can never find any in the shops the only ones I seen is when they sell them in Tesco but they come in with the ink refill bottles so I just use worm water by it self on a cloth and dabbing on the heads to clean them, it will not harm the heads but not to much water.

Some heads are on the inks them self but some have them inside the printer so I not know your printer so if the heads are inside you need to get them out you may find that some heads will just clip out put some need to be unscrewed so you got to know how they come out so be careful and not push to hard on them, if the heads are on the ink then it is a easy job to clean them,
It worth a try it worked for me more than ones.

Please all I ask is call back and just gave a vote, it will gave me some satisfaction to know am helping some one, so I will keep on helping.
All The Best: Pineworks

Click on the link below:
http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?prodNameId=372336&lang=en&cc=us&taskId=135&prodTypeId=18972&prodSeriesId=406455

Choose your Operating System
Download the software and Utility
Good luck
luciana44

try this

http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?product=372335&lc=en&cc=us&dlc=en&dlc=en&lang=en&cc=us

select your operating system then download and then run it

Thanks

got to google.com and search you will recive it.

According to the HP site they are included with win 7.

http://h10025.www1.hp.com/ewfrf/wc/document?docname=c01874792&lc=en&dlc=en&cc=us&lang=en&product=372335

Make sure you inserting the paper not deep inside just insert and stop it when you feel any resistance .and try to print something. If it is print then well otherwise you have to show it service center.
Hope this helps. Please rate my response.
Thanks.
Have a good day.

http://h10025.www1.hp.com/ewfrf/wc/softwareCategory?lc=en&dlc=en&cc=us&product=372335&lang=en&#

HP Officejet 7200, 7300, and 7400 Series - 'Paper Jam: Clear jam, and then press Enter' Message Displays on the Control Panel Display
Issue
During printing, the paper becomes stuck in the all-in-one and the error message 'Paper Jam: Clear jam, and then press Enter' displays on the control panel display.
Solution
Use the following instructions to clear a paper jam from the product:
Step one: Check for and remove any loose paper from the In tray
Do not try to remove jammed paper from the In tray. First remove any loose paper from the In tray to avoid worsening the jam.
CAUTION: Always try to remove jammed paper from the back of the printer first to avoid mechanical damage.
Step two: Clear the jam from the back of the printer
Follow these instructions to clear jammed paper from the back of the product. If the product is equipped with a two-sided printing accessory, skip to that section.
Remove the rear access door to clear the paper jam

1. Remove the rear access door by pressing the buttons on the side of the door and pulling it toward you.
Figure 1: Removing the rear access door
Rear access door
2. Gently pull the jammed paper out of the rollers.
WARNING: If the paper tears while removing it from the rollers, check the rollers and wheels for torn pieces of paper that might remain inside the product. If all the pieces of paper are not removed from the product, more paper jams might occur.
3. Replace the rear access door. Gently push the door into the all-in-one until it snaps firmly into place.

Remove the two-sided printing accessory to clear the paper jam

1. Remove the two-sided printing accessory by pressing in the buttons on the sides and then pulling the accessory toward you.
Figure 2: Removing the two-sided printing accessory
2. Gently remove any jammed paper.
WARNING: If the paper tears while removing it from the rollers, check the rollers and wheels for torn pieces of paper that might remain inside the accessory. If all the pieces of paper are not removed from the accessory, more paper jams might occur.
3. Press the button on top of the two-sided printing accessory to open the door.
Figure 3: Opening the two-sided printing accessory door
4. Gently pull the jammed paper out of the rollers.
5. Close the accessory door.
6. Reinstall the two-sided printing accessory.

Step three: Clear the jam from the automatic document feeder (ADF)

1. Remove the document feeder tray from the product by gently pulling it.
2. Lift the cover of the automatic document feeder by pulling it outward.
Figure 4: Lifting the cover of the automatic document feeder
Automatic document feeder (ADF) door
3. Gently pull the jammed paper out of the rollers.
WARNING: In the rare occurrence of a severe paper jam, you might need to remove the face plate from the front of the automatic document feeder and lift the pick assembly to remove torn pieces of paper from deep inside the automatic document feeder.
4. Close the cover of the automatic document feeder, and then reattach the document feeder tray.

Step four: Verify that the print carriage can move freely
Follow these steps to try to move the print carriage.
CAUTION: Do not force the print carriage to move if it is out of plain view or feels stuck. Forcing it may damage the printer.

1. With the product turned on, open the print cartridge access door. The print carriage might try to move into the access area. If so, allow it to move to that position.
2. Without turning off the product, unplug the power cord from the back of the product. Unplug the power cord from the power source. The power cord must be unplugged to allow the parts to be moved by hand and to reset the paper feed mechanism, without the risk of an electrical shock.
3. Looking in through either the print cartridge access door or the output paper tray, make sure the print cartridges are locked into the carriage and have not come loose. Also, make sure that there are no obstructions under or around the carriage to block it from moving.
4. Make sure the print carriage can move freely across the width of the product by gently pushing the carriage to the left and then to the right. Clear any obstructions found.
You may have to reach through the output paper tray to access the print carriage.
5. Close the print cartridge access door and plug the power cord back to the back of the product. Plug the power cord into the power source.
6. Press the On button to turn on the product.

Step five: Reload and test the printer
After you have removed the jammed paper, make sure the product is still functioning properly.

1. Reload the product with plain paper.
2. Peform a self-test by pressing and holding the RESUME button on the control panel until the product begins printing. A test page prints.

Step six: Service the printer
If you have completed all the steps listed above and are still experiencing a problem, service the product.

Here http://h20000.www2.hp.com/bizsupport/TechSupport/DriverDownload.jsp?prodNameId=372336&lang=en&cc=us&taskId=135&prodTypeId=18972&prodSeriesId=406455

Here's a link to everything HP offers for your printer. Typically it isn't necessary to have the original CD. HP will let you download essentially everything that was on that CD. Just follow the "Software & Drivers" link and select which operating system you use.

http://h10025.www1.hp.com/ewfrf/wc/product?product=372335&lc=en&cc=us&dlc=en&lang=en&cc=us

Good luck.

Hi,
There is some problem with your Print Cartridge, So Visit this link and follow the instruction.
http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=in&taskId=110&prodSeriesId=439162&prodTypeId=18972&objectID=bpd50048

Hi, Whenever you encounter such problem plug off your printer and restart your computer and then plug on it. It will work.

dowload the driver from internet...go to the service website, check fro your model driver. then donwload and install. if you dont have internet ...let me know.