20 Most Recent GE Profile Harmony DPGT750EC Electric Dryer - Page 3 Questions & Answers

You didnt give much info to go by but it could be several things, it could be the heating element, the thermostat that closes and sends power to the element, the vent in the back could be clogged and making the thermostat kick off and not letting the element stay on, It could also be the timer has went out. I would start by checking the vent and making sure it was clear and turn the breaker off and on to the dryer if one side of the breaker is not sending power you will only get 120 volts instead of 240 and the dryer will not work correct. for all the other you will need a multimeter and check one thing at a time to find the problem.

That is the rear drum support you will need to get a new one and install the entire kit.

thermal fuse

Sounds like the electronic control is bad but check your power supply first

OK you have power but, is it 220 volts. If you check that with a multi meter and have 220 volts then we can go from there and check other stuff. I am waiting to help you

Check the power cord is tight. and check that you have 220 volts then contact me back

The simplest thing may be the door is not pushing in the "safety button" in all the way. With the door open, push in the button and try to start the dryer. There should be no danger of electric shock, the button is plastic and insulated or it would short out when the door is closed. Sometimes the button needs a little lubrication -- there is a CRC plastic safe spray that improves electrical contact (Home Depot or similar)

Check breaker panel. Check voltage to back of unit. If both ok then likely need a new display.

As long as you're sure it is plugged in to an outlet that has power (make sure the breaker is not tripped), there are 2 things that keep a dryer from starting. There is a switch that needs to connect by the dryer door being closed. and there is a switch on the belt tensioner that shuts the dryer off when the belt breaks, and will not allow it to restart until the belt is replaced. Check the drum drive belt to see if it is broken, that is the most likely cause.

Yup...heating element (usually there are two) is done. Likely the first one was done long ago and the second has finally died.

They are designed to work together via USB . But will still work if they are not connected by the USB cable.

i have same problem the cable to cn8 is broken on mine. maybe yours is unplugged but so you know it's $600 for servvrvice man and $ about $300 for the part so far I have NOT found a way around it BUT I am NOT done yet. Joe Comer. You can contact me directly ayt [email protected]

micromax mmx3010p gid unlock code kya hai.