20 Most Recent
Toshiba e-Studio 2551C Multifunction Color Copier - Page 8 Questions & Answers
I'm working on a Toshiba c281 I need to know how to remove the drum.
1. Open the front cover
2. Remove waste toner box
3. Remove developer unit
4. Put down the power switch actuator
5. Remove screws (2 special screws can only be loosen) and pull out the process unit
6. Separate the transfer belt from the process unit
7. Remove the main charger unit and u can change the drum
How to reset admin and system password of toshiba estudio 2518?
- Turn off the power switch.
- Hold then Press "0 & 8" while turning it on.
- You Will Be in Test Mode Then, then press the "263" and "start" button.
- You will see your DEFAULT PASSWORD 123456 on the screen, clear the old password and enter the new password and press the "Start" key.
- Then switch off the machine and turn it back on the power socket. You can see reset your password.
How To Fix Toshiba Fax Error 0050?
24/7 Customer Services
- Efficacious Solutions to Troubleshoot Toshiba Fax Error 0050: ...
- Solution 1: Allowing Fax Machine to Redial the Busy Number. ...
- Solution 2: Placing of a direct call at the Voice Line. ...
- Solution 3: Try sending the document as a PDF attachment to an email message.
https://www.toshibasupport365.com/blog/resolve-toshiba-fax-error-0050/
Am facing a problem in my toshiba copier model 2050c. On screen said service call C449. Please can you help?
https://printcopy.info/?l=ru&mod=erc&brand=Toshiba&model=e-Studio%202505H&code=C449
Service manual online at link above
Quoting from link above: "
- Code: C449
- Description:Fixer temperature of 240°C or higher during printing
- Causes:MAIN board
- Remedy:1. Check the thermistors 1. Check if the connectors are disconnected. 2. Check if the center and edge thermistors are in contact with the surface of the fuser roller properly? 3. Check if the center and edge thermistors are not deformed or dirty. 4. Check if the harnesses of the center and edge thermistors are open circuited. 2. Check the heater 1. Check if the heater is broken. 2. Check if the connector of the heater is disconnected. 3. Check if the harnesses are connected properly to the terminals of the heater lamp. 4. Check if the thermostat is blown. 3. Check the MAIN board 1. Check if the connectors CN10 are disconnected. 2. Check if the conductor pattern on the MAIN board is short circuited or open circuited. 3. Replace the MAIN board 4. Check the power supply 1. Check if the connectors are disconnected. 2. Replace the switching regulator. 5. Clear the status counter After repairing the matter which caused the error [C449], perform the following: 1. Turn ON the power while [0] and [8] are pressed simultaneously. 2. Key in "2002", then press [START]. 3. Change the current status counter value "9", "19", "21", "22", "23", "25", "27", "29" or "45" to "0", then press [OK] (to cancel [C449]). 4. Turn the power OFF and then back ON. Make sure that the equipment enters the normal ready state. "
Not finding what you are looking for?