2005 Kymco Stryker 125 "wheel hard turn times" Questions

wheel) to the "inlet valve open" position so that the cover clears the "inlet valve rocker". Be careful that you do not damage the top cover gasket (made of rubber) or you will have an oil leak and no

...so hard that the key will be hard to get out. If so turn the wheel hard to left and try to remove the key at the same time. Repeat this for the right also. It has worked for me a lot. Hope this

...lever push it in and pull the clutch atsame time it should b hard to pull than if there is no key looking thing by handle bars shift down if there is turn it while holding in clutch and shift down ...

...hard, keep pedal down, open brake nipple relase fluid as soon it stop spurting, close tight and repeat process until all air bubbles are out from system, fill brake fluid reservoir. As the bike is on ...

hard time today going into neutral Just started doing it You're clutch cable needs to be adjusted. Most likely you can gain enough "pull" up at the hand lever. The adjustment will be turned clock wise

hard and needs the chain replacing due to it strecthing. on the swing arm at the back is their two bolts sticking out the end of each swing arm their should be one in one side of the swing arm and one

...wheel. On the shock is a large nut that will increase or decrease the tension on the shock.Increasing the tension is better for two up riding . Decreasing the tension is better for solo riding. You ...

...wheel causeing the skidding you speak of secondly increase the distance you travell from the vehicle in front this will giveyou more time to slow down without the need for harsh brakeing if you ...

hard to turn).I bolted it back on temp .to see if it turns with battery connected,and it does.With this bikes strange setup of the starter motor on the top of the alternator,do i need to remove engine

front brakes restrict wheel turning, bike hard to push Time for a new caliper on your 27 year old classic Gold Wing.