Kymco Motorcycles - Recent Questions, Troubleshooting & Support


When you say the plug is hot, you presumably don't mean the spark plug so which plug is getting hot? Whichever plug it is it shouldn't be getting hot - heat is an indication of excess current flow or a poor contact. I suggest you add more information in the comments.

Kymco... • Answered on Jan 02, 2021


Usually related to needing service or battery state. Remove the battery terminals and clean the battery posts and the connector on the wire. Fully charge the battery. Smear both with some Vaseline and reconnect. The code should be gone.

Kymco... • Answered on Dec 19, 2020


I wonder what your fault is .......................

Kymco... • Answered on Dec 03, 2020


I looked all through the manual and could not find a fuse box. It looks like they may all be inline single fuses.

Kymco... • Answered on Nov 03, 2020


Fuse replacement needed.

2006 Kymco... • Answered on Jul 19, 2020


You don't mention which bearing it is or how you know that they've gone bad. In any case, here's a link to the service manual.
http://www.scribd.com/doc/13244097/Xciting-500-Service-Manual-ENG

2005 Kymco... • Answered on Jun 06, 2020


kymco 500 has no air temp sensor,ecu reads water temp for coldstart enrickment.a new sender wont fix it ether,sender needs to read 10 degrees warmer to start

2005 Kymco... • Answered on Jun 06, 2020


If it will not crank then the battery is probably drainedCheck battery voltage with key on, key off & cranking & get back to meRide SafeBike-Doc

Kymco Xciting... • Answered on Jun 06, 2020


Something has to be draining your battery. Try to find out what is still pulling power. What could still be running even when your ignition switch is off. Usually it's the parking light. Depending on your make the last turn of your key after your lock, is a parking light notch. My Hyabusa has that kind of notch and I'm always being alerted that my back light is still on after I'm in the house.

Kymco Xciting... • Answered on Jun 06, 2020


If the battery won't hold a charge take it to an auto parts store. they'll usually check it for you on a load tester for free. Typically the issues of the battery discharging stem from the charging system. I would check the stator output as well as the regulator. More than likely your problems stem from those areas. I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_5bac37c3cb991fdb

Kymco Xciting... • Answered on Jun 06, 2020


  1. buy a manual it will tell you how hard it is

2005 Kymco... • Answered on Jun 06, 2020


right in the back of gear box same size as the drain bolt,. put in the right amount, per the manual, if you put in to much it will over flow,.

2006 Kymco... • Answered on Jun 06, 2020


There's a button covered with rubber on the left side of the dashboard. Using a thin stick, push this firmly and hold (while the bike is running) for about 1 minute. Fixed.

2005 Kymco... • Answered on Jun 06, 2020


A large screwdriver will break open the seat clamp.

Kymco Xciting... • Answered on Jun 05, 2020


Check drive chain tension and lubrication. Also check for excess wear on drive sprocket.

Kymco Xciting... • Answered on Jun 05, 2020


Try dissconnecting the Negative Terminal on the Battery. Leave off for a minute or so, should reset it.

2005 Kymco... • Answered on Jun 05, 2020

Not finding what you are looking for?
Kymco Logo

927 questions posted

Ask a Question

Usually answered in minutes!

Top Kymco Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6647 Answers

Brad Brown

Level 3 Expert

18664 Answers

Vernon Taylor

Level 3 Expert

7446 Answers

Are you a Kymco Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...