2006 Isuzu Ascender "idle air control valve" Questions

idle surges and retreats about 7 or 8 times before smoothing out. Surging to 1000 RPM then dropping to 300, back to 1000, etc. I've cleaned the air filter, as well as the mass air flow device properly

idle air control valve, but getting the codes would help end speculation. Really sorry for your trouble and I hope this helped. Best wishes. Low / uneven idle problem can cause by a lot of components.

Idle Air Control (IAC) Valve Removal Disconnect battery ground cable (14301). Refer to Section 14-01 . Disconnect the engine control sensor wiring (12A581) from the idle air control valve (IAC valve)

...Idle air control actuator - Wikipedia, the free encyclopedia https://en.wikipedia.org/wiki/Idle_air_control_actuator An idle air control actuator or idle air control valve (IAC actuator/valve) ... ...

...idle air control valve located It's IAC - idle air control valve , not fuel injector idle air control valve. It's located on the throttle body -air inlet for the engine . Idle Air Control ...

...Idle Air Control Valve Testing and Cleaning https://www.youtube.com/watch?v=jgbTdyeaWbM Cleaning an Idle Air Control Valve and Throttle Body (Kia ...

...idle air control motor and solenoid, stuck throttle cable if equipped, throttle position sensor Hi, First on the throttle body the is an idle air control valve disconnect the wire, then remove the ...

...idle air control underspeed error? how do i fix 1999 ford explorer change the idle air control valve. Idle Air Control (IAC) Valve OPERATION The Idle Air Control (IAC) valve controls the engine idle ...

...idle air control valve. I've been told it's near the firewall. Do I have to remove the whole intake to access it, or is there an easier less costly way of doing this? Help! it's on the throttle body. ...

...idle air control valve electrical connector. 3.Detach the idle air control valve wiring harness from the stud. 4.Remove the idle air control valve. Remove the two nuts. I hope this is concise enough ...