...thermostat of a 2004 Mazda 3 follow the big coolant pipe coming out of radiator and where it joins at the engine. its joint with thermostat. few bolt undo and change thermostat. make sure after ...
...3's and a new thermostat is the fix. ...Damn on most cars a thermo is $4-10, but evidently Mazda makes you ... While astuck open thermostat won't hurt the engine, it will certainly ... Mazda P0126 ...
...3 2005 2005 Mazda Mazda3 2.3L MFI DOHC 4cyl Before servicing the vehicle, refer to the precautions section. Disconnect the negative battery cable. Drain and recycle the engine coolant. Remove the ...
...thermostat on a Mazda 3 2005 Change it by removing the housing (where to top radiator hose connects to the engine block) , Replace the gasket and the housing, tighten all the hose clamps you took off ...
Question about Mazda MAZDA3
...3 hatch andvive noticed my temp guage does not move. Where is the fuse for this? the coolant temperature sensor should be on the thermostat housing on the engine, if you have a look where the coolant ...
...thermostat on a 2008 mazda 3 sport i Just find the upper radiator hose and follow it to where it goes into the block. You should see a "bubble" there with a bolt on either side. That's the thermostat ...
MY BAKKIE IS PUSHING WATER THRU THE CAP AND IS OVERHEATING WHAT CAN BE THE PROBLEM Bad thermostat, cooling fan not coming on.
My thermostat went out on my 2004 mazda3 how do I replace it? Please see my tip at http://www.fixya.com/cars/r5929960-s_thermostat and let me know if you have questions.
p0126 code That is a coolant temp not reaching closed loop operating temp. Most likely the thermostat is the problem.
...thermostat control on my mazda 3 2004 but dont know where to start there are screws hidden by round covers. ***** with flat screw driver. hidden screw will be shown. remove the radio and dash grille. ...
636 questions posted
Usually answered in minutes!
375 Questions
370 Questions
157 Questions
30 Questions
18 Questions