...TCM(transmission control module) There are wide ranging possible causes: open in trans control relay output circuitintermittent wiring or connector problemsinternal transmission problem(4th clutch ...
Question about Kia Cars & Trucks
...TCM power relay control circuit/ open. I have already checked the relay under the hood and it was not blown. I have purchased part # 95445-39052 which is listed for this code but I can only see a ...
...control assembly to motor ground ECA Code: 628 = Excessive converter clutch slippage This is what I tested so far 1 the inertia switch has power to one leg of 7V 2 The relay is good I tested it 3 the ...
...control modules) it also has what is called limphome mode, on failure you lose gears, a gear can be cut, to to stop further slippage and heat damage. and all TCM have error codes. but how to get them ...
Question about Cars & Trucks
control module then the pump? Usually a PCM just makes the grounds, I don't know if the BCM does the same or what? If I ran power to the pump wire and or made the ground good, would it cause a problem
...CONTROL UNIT - OUTPUT MAL P1778 ELECTRONIC V/V MAL P1779 START RELAY MAL P1779 ENGINE TORQUE SIGNAL FAULT P1780 PUSH - PULL SENSOR MAL P1780 ENG TORQUE SIG ERR(CAN COMM) P1781 ACTUATOR MAL P1782 ...
Question about Jeep Cherokee
...relay, not the BCM or TCM or PCM. the shifter, does page 8w-31-15 seen below, the red arrow drives said relay the book is free on line, posted by me 300 times, WJ jeep or go to mitchells and read, at ...
...control module (TCM) to verify that all parameters are met for starting. When all parameters are met the ECM grounds the control circuit of the Starter relay closing the switch providing battery ...
Question about Jeep Cherokee
...Relay P0748 Jeep Governor Pressure Solenoid Circuit Condition P1765 Dodge Gov Press Not Equal to Target not15 20 PSI these are not sensors they are solenoids an are controlled by the TCM an all are ...
...control circuit OR 42 Fuel level unit - no change over miles OR 42 Z1 voltage missing when autoshutdown circuit energized (The Z1 voltage is the voltage of the circuits fed by the autoshutdown relay. ...
902 questions posted
Usually answered in minutes!
1,380 Questions
1,162 Questions
698 Questions
659 Questions
325 Questions