2006 Chevrolet Silverado 1500 2WD "heat floor vents heater" Questions

My heater control will not switch to defrost or floor, I have plenty of heat through the vents but no defrost or floor heat. blend door motor on heater box needs replace or at least checked

...floor but not as hard as it should. The fan speed only works on high. It is the same for the heat. check the actuator motor on the heater sounds like the motor is not directing the air as it should. ...

on the passenger side 1 for fresh / recir. air and the other position of heat/cold on drivers side has 2 also blend air and defrost/ floor . these are fun to remove usually held in with 2 5.5mm screws

...heat, everywhere except for passenger floor vent, which is icy cold. Had disconnected air conditioner so it would not run during winter. Should this disconnection cause the problem? Is it possible ...

...floor for heat, heat comes out of defrost as well. Your heater box has what is called a blend door in it, this directs the flow of air to its destination selected on the control. Sometimes something ...

heat on windshield can not change to floor Check under the dash behind the radio where the cable that changes the position of the vent guides to make sure it is not loose. I've never checked this on a

...I called the dealer and the parts were 85-125. I got it From TBA Auto (local store) for 39.00. A 20 min job at most. 1999chevyZ71extended cab can not get heat from defroster to the floor HELP ...

...heat and cold and one for routing the air. When I flip the switch so that the air should be diverted to the front windshield (defroster), it does not occur. Air continues to flow through the dash ...

...heat won't go to vent or floor, blows strong out of defrost vents but does not switch to other vents. I have the temperature control heater, and while I can get good strong heat blowing out the ...

...Floor Vent heat only My 12 passenger econoline has the ac/heat/vent controls on the front dash. No back controls. Therefore, my a/c works fine both in front and back top vents. However, when I change ...