20 Most Recent 2008 Chevrolet Silverado 1500 Questions & Answers

I have a auto repair shop and a customer has the same problem my genisys code scanner pull a radio communication code U0199 which is lost communication with door control module A. I will further diagnose this system and post later hope some of this will help you with yours

2008 Chevrolet... • Answered on Feb 24, 2021

By a cheap odb2 reader read code then delete codes,,with no check engine light on it will crank with remote start ,,a few times,,,,or til the light reappears ,,,you can also take the neg cable off the battery for 30 seconds to clear the codes,,, remote start should work after that if no engine light

2008 Chevrolet... • Answered on Jan 07, 2019

check wheel bearings for service and adjustment The bearings could be allowing the disc rotor to be hitting on the calliper housing

2008 Chevrolet... • Answered on Jan 15, 2016

It is under the hood and has the wiper symbol on it. usually on the driver side.

2008 Chevrolet... • Answered on Nov 29, 2015

Way too involved here; get the manual and read it. If you do not know what you are doing get some one who does..

2008 Chevrolet... • Answered on Sep 02, 2015

It's underneath the vehicle on the frame rail. 25721440-ugnrgg55anxmatdjuqxukoj1-4-0.jpg

2008 Chevrolet... • Answered on May 30, 2015

I'm sorry to hear about the troubles you are experiencing with your Silverado Jeanette. It sounds like the detailer may have gotten liquid inside the driver's door panel/armrest. Since you say the door locks still work with the fob and all the fuses checked good then I can only assume water intrusion in these switches is the problem. Water could also cause the speaker to short out and become non-functional. This year model truck is notorious for door lock actuator, power mirror, and speaker failure. I've had to replace all on my 2008 Silverado along with the mirror switch. There are several good videos posted on YouTube on how to troubleshoot these problems which may be helpful if you are a DIY kind of person. Otherwise you'll have to take it to a trustworthy mechanic to do the troubleshooting and repairs for you. Hopefully you know someone who is good at this sort of thing because the dealerships will charge you a small fortune to repair them. Have you contacted the detailer to see what he may do to help with the cost? It couldn't hurt!

2008 Chevrolet... • Answered on Mar 30, 2015

Did it ever over heat The intake manifolds on chevys can't take heat. Cheak your antifreeze for oil in it look at your dip stick look for white fome. If you see eighter of these condutions you need to fix the intake manifold fast or the engine will be shot. It could be a valve problem to how many miles are on it .But check the oil and antifreeze

2008 Chevrolet... • Answered on Mar 13, 2015

The evos vent solinoid or vent valve,, i forget,,,is stuck open,,, its the one on the intake ,,, drive side towards top and front,, see youtube,,,the evaperating fuel fumes are flooding the engine so it wont start after sitting awhile,,,does the samething on fillups,, try this next time it is a no start,,, hold pedal to floor and keep turning it over til it cranks,no longer than 30 seconds,,the part is only 30 bucks you can change yourself ,,you can clear the engine code if it fixes it by undoing the ground cable off the battery for 30 seconds,,,check the codes befor you delete,,its either the vent valve solionoid, vent valve purge, i cant remember,,, the code are po4** in that range

2008 Chevrolet... • Answered on Mar 07, 2015

Call your Chevy dealer with your VIN number. They can run it and see if there are any outstanding recalls.

2008 Chevrolet... • Answered on Mar 01, 2015

Once they lock up they are done. They need to be replaced. They should come with an instruction sheet for replacing them.

2008 Chevrolet... • Answered on Mar 01, 2015

Slim Jims do not work very well. There is a new tool that is heavier than a hanger. You sneak it down between the door jam and door frame and either push the power door lock button or pull the unlock knob in the door panel to unlock the door.

2008 Chevrolet... • Answered on Oct 13, 2014

My advice is don't causecany more damage more than necessary. Sounds like it is going to collapse , suggestvyou have it checked out by the professionals. Think you are going to need a replacement unit

2008 Chevrolet... • Answered on Oct 10, 2014

Your asking for a guess- are you? Your going to have to do some testing, when it comes to vehicle problems What is squeeling? the belt the pump How about a failed steering rack? Do you have one of those? Suspension parts failed?

2008 Chevrolet... • Answered on Oct 04, 2014

Jason, unfortunately this is a common problem with this year model truck. I've replaced the driver and passenger door lock actuators on my '08 Silverado. If you are a DIY guy you can buy an actuator for around $120 and save the $100+ hourly rate the dealer will charge to do it. There are several good videos on YouTube that show how to remove the door panels with a few common tools. It's not difficult but can try your patience. Post any follow-up questions you may have.

2008 Chevrolet... • Answered on Sep 17, 2014

Pull bottom radiator hose..or open petcock on passenger side of radiator(bottom) Drain fluid Replace hose/close petcock Fill w newfluid Let runfor a few min w cap off to burp system and refill as needed Run until thermostat opens...

2008 Chevrolet... • Answered on Sep 01, 2014

Not finding what you are looking for?
2008 Chevrolet Silverado 1500 Logo

285 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

john h

Level 3 Expert

23950 Answers

Joe Taylor
Joe Taylor

Level 3 Expert

2228 Answers

Ryan Lutton
Ryan Lutton

Level 3 Expert

1266 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Silverado 1500 Chevrolet

  • Silverado 1500 Chevrolet

Most Popular Question

unlock 2008 1500 chevrolet silverado

  • Cars & Trucks