Aurora Electronics AS1018CD Shredder "paper work reverse" Questions

work by running it on reverse for a moment then sliding it to auto. It stopped. Then I did it again. This time auto ran just for a second then stopped. I did it a third time but I had a sheet of paper

...it will not shred paper, it will only work in reverse. Unplug your machine and clear the paper jam so the little plastic switch will be able to go down and it should work. Hope this works for

...not shred. there should be a forward/ reverse switch that is used to unjam paper being shredded. check that if it is automatic then check for paper stuck in the shredder causing the reverse

...work, unplug it, turn the shredding unit off and pick out whatever paper you can see, both top and bottom. Watch your fingers, the cutters are sharp. I JUST CLEANED ONE AT WORK AND IF YOU ARE NOT ...

...work for 1/3 of standard paper size and the go into reverse. Is a switch not working? I'm going to say it needs oiling. Try oiling the gears and cutting blades. You can buy paper shredder oil at ...

paper. The reverse will work, but not the actual shredding. Is the sensor light broken? check and see if there is a jam of paper inside the unit or around the sensors I to am having this issue. So far

Reverse works, but will not run when paper is inserted. All of the blades spin fine. Reverse works. The light says it is ready, but when you push the paper in, the blades will not start turning. ...

...reverse Auto Mode Not Working Select the "Auto" option and feed paper into the center of the feeder tray if the shredder is only working in reverse mode. The sensor is located in the middle of the ...

work in reverse but nothing happens when i insert paper to shred. light is on will not shred even 1 page. Won't feed and light is on. Will reverse with NO DOCUMENTS in it to reverse. I DO WANT ANSWERS

...Reverse works. revers usually always works, i could be that the paper sensor is not working. there is usually a light beam or other mechanism that senses that paper is in the feed if this is not ...