Maytag Neptune MAH5500B Front Load Washer "reset circuit" Questions

...reset the Circuit Breaker. Now plug in the dryer and try to run it. If it does not work again check the Circuit Breaker again if it is tripped again unplug dryer and call someone that can help you or ...

cycle. Unplug washer and let sit for 5 min. Then replug the cord back in to reset the circuit board. I this doesn't work, could be a bad board. heck with dealer on recall notices on bad curciut boards

...of the modes. Check power circuits and plug in's , if there is moisture use a heater to remove and reset the

...circuit board to "reset" when you plug it back in. Then give it a try. I'm sorry to hear that, your motherboard is likely fried. But just to be sure, try unplugging the washer and then plugging it ...

...reset procedure, fuse, circuit breaker, something I can do in the machine to restore operation? Thanks, Mike I am afraid there is no breaker or fuse inside the machines that will cause the control ...

...reset circuit braker no luck. does the dryer use a 240 volt plug in there are two brakers one for heat and the other to run dryer look for two 60 amp brakers they may be at pannel or located out-side ...

...circuit breakers(pair)--push the breakers OFF, then ON to reset. Recheck for 220 volts at dryer socket--if ok now, try the dryer. You need to use a voltmeter for this checking. If it starts, then ...

...RESET, DID NOT WORK. If your washer doesn't seem to work at all, check these: No power Lid switch No power Check to see whether power is getting to the washing machine. Is it plugged in? Has a fuse ...

...circuit board to reset. So far as the clothes being wet, you may have a situation where the load became unbalanced and the drum struck the interior floor of the washer where a switch is located. This ...

...reset circuit breaker. ? Close door and push the start/pause pad to start the clothes washer. For your safety, washer will not tumble or spin unless door is closed. ? This may be a pause or soak ...