Reddy R155D Utility Heater "keeps igniting going" Questions

the igniter doesn't stay red hot. Why does the heater quit? Replaced fuel, filter, and hoses Installed new vanes. Adjusted the pressure In general... I guess: (no model, make, serial number or year ...

knob. When you push down on the knob, it is supposed to press down on an electromagnetic lock which keeps the gas valve open when the flame is burning. When the knob or shaft isn't pushing down enough

Model R110 Does not ignite on startup Have taken the cowl top cover off and observed the system on startup. The fan comes on but there is NO spark at the plug and NO ignition. What component may be ...

...turns on, however all of a sudden the gas lines go out and everything ignites again. This process keeps repeating over and over. The module is operational, the thermostat is working and the blocked ...

starts go go but dont throw heat the heater just keeps on flooding what do i do? change the igniter? You can check the igniter by touching the cover over the igniter. It should be warm not long after ...

the ignition light comes on, gas flames starts, when ignition light goes, flames go out and furnace keeps running blowing cold air Sounds like open limit switch or roll out switch.

the furnace model# DGAA070BDTB will ignite then almost immediately go out it will the ignite again then go out then the blower motor will come on it will then try to ignite again with blower on til ...

coleman evon BGU10016A put in new ignition light and still wont heat up, what next Check to see if you are getting power to the ignitor... if not then the ignition control module is bad or there is ...

goodman furnace gmh95090cxac wont stay lit keeps clicking will lite then clicks back off what would be the problem the glow rod will lite then go dim a number of times then the burners try to ignite ...

laser 73 the wires came loose on the igniter then all the lights started blinking and now it wont work hot surface ignitor or spark type of ignitor? does it look like a ceramic tube going into the pot