Reddy Heating & Cooling - Recent Questions, Troubleshooting & Support


After 19 years of service, your Reddy heater probably is ready for replacement.

Reddy Heating &... | Answered on Nov 16, 2020


Contact Reddy directly to request the manual.

Reddy Heating &... | Answered on Oct 29, 2020


check your cad cell. replace this. it is not detecting a flame. replacing the cad cell will fix your problem. when it shuts down it goes into lockout.

Reddy... | Answered on Jan 07, 2020


Never try and light a furnace when you have a glow coil ignitor. Even if you managed to do so it would reach high temp and limit would stop it. . trained technician can do this but why? If your glow coil is glowing constantly after start up than mast likely you have a control board problem. Call a technician to troubleshoot it

Reddy Heating &... | Answered on Dec 31, 2019


Replace the sensor,the sensor won't allow the unit to fire if it is dirty or defective,they aren't expensive.probably under 35 bucks

Reddy Heating &... | Answered on Oct 13, 2019


Flame sensor is defective if it is igniting and attempting to burn then goes out replace the flame sensor

Reddy Heating &... | Answered on Oct 07, 2019


...."I own one just like this and it is true at the beginning I did not know how to make the cold air work but once I play with the buttons everything worked fine. You have to press mode twice then press the minus button until the air gets cold. The instruction are not clear but the item is great, I used it year round." Prem air PCH1033 RC 1 8kw Ceramic Tower with Remote

Reddy HEATER... | Answered on Jul 23, 2019


is the sensor for the thermocouple located in the right spot in the flame,remove it and if you have access to a propane torch,heat the end till its red hot and leave it connected to the gas valve,then start the unit and this will tell you if the sensor is properly positioned in the pilot flame on the unit itself,if not you could have a defective new thermocouple or another safety device keeping it from staying lit or the gas valve is faulty

Reddy HEATER... | Answered on May 09, 2019


Jerry, you may have a low pressure output on the air pump behind the electric fan motor. There are 2 plastic plugs at the rear cover where the filter is. One is just a plug. If you have a low pressure air gauge say 10-20 psi max, you can remove this plug and screw it in that hole. Do not over tighten the gauge. The other plug increases air pressure when you turn it clockwise, counter clockwise to decrease. this model usually is set around 6 - 6.5 psi. If the pressure does not increase, it may be time to remove the rear pump cover and investigate the filters, rotor & carbon blades.

Reddy Heating &... | Answered on Jan 28, 2019


How to change Dearborn from natural to propane

Reddy Heater... | Answered on Jan 25, 2019


No it not, Sounds like the bushings are worn. It is time to replace motor. the part number is fasco 105336-01.

Reddy Heating &... | Answered on Jan 19, 2019

Not finding what you are looking for?
Reddy Logo

1,638 questions posted

Ask a Question

Usually answered in minutes!

Top Reddy Heating & Cooling Experts

Paul Carew

Level 3 Expert

3527 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Fahr Quad

Level 3 Expert

774 Answers

Are you a Reddy Heating and Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...