Question about HP DeskJet Office Equipment & Supplies
...the banging noise, then there may be a problem with the stepper motor or gearing (plastic gears). This is not normally user serviceable and is not cost effective to repair. You buy a new
Question about Office Equipment & Supplies
Stepper motor is more rotating? showing error code E1, but Stepper motor is more rotating Check the speed sensor If you wish to get some details; check the site linked here. Pull up older posts. http:
Question about SATO Office Equipment & Supplies
...stepper motor does not move although it apears to be receiving at least some power as it resists manual moving. When powered off, the rapid ticking sound slows in frequency and the power to the ...
...stepper motor can not go past a cetrain point at which the pointer twitches. My solution was to strip out the console and swap the tacho and speedo gearing. If your are technically minded it is quite ...
Question about Star Office Equipment & Supplies
...stepper motor may be driving the printhead beyond it furthermost right stop position and binding the head. The print head carrier stop may be bent or out of position allowing the carie to lock on the ...
...(india) You will need to replace the main drive motor assembly. That stepper motor is a common fail item. You have to remove the rear cover, the MFSYS and MCU board assembly to access that
stepper motor? I had to contact support, but all they do is make sure you try connecting the printer to the wall outlet, then a different wall outlet, then reset to factory defaults. After that didn't
Question about HP DeskJet Office Equipment & Supplies
...stepper motor's heating up or malfunctioning. Another cause could be the excessive shifting of the layers.(Usually occurs on the Y-axis) Possible Causes: - Loose Belt - Broken belt clamps - Stepper ...
STEPPER MOTOR uses more than 130% of the maximum number of steps to move the PLATFORM of INSERTER SUPPLY 3 down to the expected position, the INSERTER SUPPLY CONTROL BOARD determines that the PLATFORM
Question about HP DeskJet Office Equipment & Supplies
...stepper motor controlling the scan arm is defective. Replace motor or entire unit. Check for damage to Flat Flex. Cable (FFC) between the scanner unit and formatter board. Repair the ends (trim about ...
18 questions posted
Usually answered in minutes!
2,162 Questions
707 Questions
530 Questions
316 Questions
318 Questions