...screws from the back, the front bezel snaps off and the door behind the bezel need to be removed. Watch the wires connected to the bezel, they need to be attached in order to turn on the set. The ...
...screws are. If they are labeled great, if not hopefully they are obvious to see on the motor or roller. Hope this helps. That one foot left unretract are basically cause by by over retract. Once the ...
...screws take this off and it should be right behind it. There are six controls on a little box one row says focus and the other says screen don't adjust the screen controls. In some cases these are in ...
...screen control. (it would be like a master brightness.) you will have to removed the front bottom plastic from the tv, look for 2 to 4 screws. then gently remove the front. sometimes the also add ...
...screen, 2 hidden screws must be removed. These 2 screws secure the bottom corners of the front screen and are installed from the back. 7. Remove the plastic housing where the lamp unit was removed: ...
...SCREEN adjustment on a block inside the TV. I have the 57" model of the same series of TV's and just had to do some work on it. If you remove the front panel and the small wooden panel behind that, ...
...ADJUSTMENT. AND I DID THEM MYSELF. I HOPE THIS HELPS. http://www.somelifeblog.com/2007/06/sony-projection-tv-red-line-repair.html PRIDAH hello, i removed all the screws from the back of the tv( ...
screen too. Any suggestions? Is it time for new one or can this be fixed? Good day, cjnewcarguy; If you like new cars you may enjoy a new LCD Flat Panel TV. Try unplugging the TV for about 2-3 minutes
screen--that is held in by 2 screws on either side in the back and two tiny ones where the front control door is located. Behind it there is a inspection plate--if you remove it you will see the board
258 questions posted
Usually answered in minutes!
1,031 Questions
445 Questions
373 Questions
357 Questions
327 Questions